Magic mill MUR150 User manual

Owner’s Manual
HOT WATER URN
MUR150, MUR200

Model#: MUR150, MUR200 Supply Voltage: 120V
Wattage: 1150W Temperature Range: 86-212° F
pg 1
SPECIFICATIONS
FEATURES
Lid
Body
Level
Indicator
Faucet
Indicator Light
Power Switch
Temperature
Control
Easy Carry
Handles
Lid Knob

pg 2
IMPORTANT SAFEGUARDS
This appliance is for HOUSEHOLD USE ONLY.
When using an electrical appliance, basic safety precautions should always
be taken, including the following:
1. READ ALL INSTRUCTIONS BEFORE USE.
2. Unplug from outlet when not in use and before cleaning or when
assembling and disassembling the unit
3. Do not touch hot surfaces. Use handles or knobs. To protect against
electrical shock do not immerse base, cord, or plug in water or other
liquid.
DO NOT
IMMERSE CORD, PLUG OR BASE UNIT in water or other liquids.
5. Close supervision is necessary when any appliance is used by or near
children.
appliance has malfunctioned or has been damaged in any way. Return
appliance to the nearest authorized service facility for examination, repair
or adjustment.
7. The use of accessory attachments not recommended by Magic Mill may
8. Do not use outdoors.
9. Do not let power cord hang over edge of table or counter, or touch hot
surfaces.
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. Always operate the appliance on a smooth, even and stable surface.
12. Do not use appliance for anything other than intended use.
13. Do not move appliance containing hot liquids.
14. Always ensure the voltage on the rating label corresponds to the voltage
in your home.
15. This appliance has a polarized plug (one blade is wider than the other).
not attempt to modify the plug in any way. Always unplug the appliance
when not in use.
16. Never immerse the machine in water. If the machine has been soaked, it
must be dried and checked by a specialist before using it again.
17. User should stay in the vicinity of the machine while machine is in boiling
state .
18. The minimum volume to operate must be up to 1/3 of the maximum
capacity.
SAVE THESE INSTRUCTIONS

OPERATING INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USE
water and dry with a clean dry cloth.
1. Make sure the Temperature Controller is set at “0” position.
2. Fill cool water into the Urn to at least half of total capacity
3. Cover the unit with the Lid.
4. Plug the Power Cord into electric outlet.
5. Turn the Power Switch "ON", and the Indicator Lamp will indicate the
power is connected.
6. Turn Temperature Controller to the temperature that you prefer.
8. When the Indicator Lamp light up, the brewing process is completed. The
urn of hot water is now ready to be served.
9. When the temperature cool down about 41-50° degrees F less than the
number that you set, the system will re-start to heat up automatically and
10. If user sets the Knob of Controller beyond (or very close) to the Number
of 212° F, the machine will always be maintained in “Boiling State” AND
Controller away from the rated of 212° F (or beyond 212).
CAUTION: Do not touch the outside of the appliance during use! IT IS HOT!!!
pg 3

CLEANING & MAINTENANCE
cleaning. Make sure the unit has cooled down completely before cleaning.
2. Pour a small amount of hot water into the tank. Rinse with hot water until
it runs clean.
3. Clean interior of unit and any scale or sediment from the element with a
4. Rinse with hot water until the water runs clean.
5. Remove the lid and clean.
6. Clean the exterior with water and detergent. Do not use harsh abrasive
8. Always remember to empty and rinse the urn with hot water before using
again.
DO NOT SUBMERGE THE BASE UNIT OR CORD INTO WATER OR ANY OTHER
LIQUID OR THIS MAY DAMAGE THE UNIT.
Storing Instructions
∙ Be sure all parts are clean and dry before storing.
∙ Store appliance in its box or in a clean , dry place.
Never store unit while it is hot or wet.
De-scaling:
In hard water areas scale will form on the element and interior. This will
on a regular basis, using a suitable de-scaler recommended for stainless
steel kettles. Follow the instructions provided with the de-scaling product.
pg 4
9. When using tap water it is important to clean the bottom heating
element and the sides of the unit once every two weeks.
10. To remove calcium deposits, boil water with vinegar or lemon juice.
NOTE: any damage to the unit caused by calcium deposits is not covered
under the warranty.

2 Alpine Ct. STE 102 ∙ Chestnut Ridge ∙ NY 10977
201.785.8840 | [e-mail]
V6.16