Makeblock Super Gamepad Instruction Manual

Building Instructions
Super Gamepad

Take out the wood boards.
12Install the power module.
Pro tips
Use the sandpaper included to sand a smooth finish
on the wood board before you start installing it.
The wood board has front and
back sides. The front side has
marks while the back side has
no marks. Make sure you
correctly identify the front and
back.
Front (with marks)
Back (without marks)
The marked
side faces up.

4Connect the power module and speaker.
Insert a 20 cm connection cable into the power module.
3
10 cm
20 cm
Pass the cable through the square
hole next to the power module.
10 cm
20 cm

5Fix the speaker to the wood board. 6Connect the servo and the servo driver. Set the servo hub to its zero position.
7
Turn the servo hub clockwise all
the way down to the bottom. Turn the servo hub's opening to the
side of the servo with a ring mark.

8Add the servo.
M3 *14mm
M3 *20mm
1:1
Place the servo in the
square hole as shown.
Tighten the studs.
9Apply a sticker.
Make sure to line up the
marks on the wood
board and sticker.
Remove the gesture sticker
from the sheet.
Flip
D1.2.5_KS010056000

12 Install the servo driver. 10 Install the wood board as shown.
Make sure the mark on the wood
board points to the left.
11 Connect the speaker and servo driver.
10 cm
20 cm
Flip

13 Insert a 20 cm connection cable into the port on the other side of the servo driver. Place batteries in the holder.
14
10 cm
20 cm
Pass the connection cable through the
square hole next to the servo driver.
1
2
3
Make sure you put batteries in the battery
holder based on their “+” and “-” signs.

Attach the battery holder to the wood board.
1615 Take out a hook-and-loop fastener and attach its two sides to the battery holder
and wood board.
Attach the fastener to the side
which has no switch. Attach the other
side of the fastener.
Thread the cable of the battery
holder through the square hole.

Remove these wood boards from the sheet.
18
Slot in side boards.
17
Follow the same steps to insert
the other three side boards.
Attach a
rubber band.
Flip

Install another Halocode.
20
Install Halocode.
19
M3 *14mm
M3 *20mm
1:1
The side with numbers
should face up.
Follow the same
steps to install the
rest of the screws
and studs.
Tighten the stud.
Push the screw through
the hole 2 on the disc,
hole 2 on the wood
board, Touchpad 2 of
Halocode, and the stud.
Tighten the screw.
Push the screw through the hole 1 on
the disc, hole 1 on the wood board,
Touchpad 1 of Halocode, and the stud.
Follow the same steps
to install the rest of the
screws and studs.

Install the LED matrix.
21 Connect the modules. 22 Assemble the gamepad.
23
M3 *14mm
M3 *20mm
1:1
1Connect the servo
driver and Halocode.
Connect the power
module and LED matrix.
2
Connect the
battery holder
and Halocode.
3
Tighten the studs.
Attach a rubber band.
Attach a rubber band.
Attach a rubber band.
Attach a rubber band.

Apply stickers. Nice! The super gamepad is ready!
24 25
Remove the stickers from the sheet and
stick them to the places as shown.
D1.2.5_KS010056000

Now, return to mBlock on your PC or iPad and program your project.
26
mBlock
https://hezi.makeblock.com