MantelMount SSB40 User manual

TM
MantelMount SSB40A Wall Adapter Addendum PAGE 1
SSB40 Wall Adapter Addendum
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
Please read this entire manual before you begin.
If you have any questions, visit MantelMount.com or call (800)-897-9755.
This Addendum is not a stand-alone set of instructions, it is only to be used
in conjunction with the MantelMount MM340 or MM540 Installation Manual.
The SSB40 Wall Adapter is a direct replacement for Item {32} Wall Frame.
ITEM NO. PART NUMBER DESCRIPTION QT Y.
1
2
3
4
15044 1
15055 1
12179 6
14126 6
SINGLE STUD UPPER BRACKET
SINGLE STUD LOWER BRACKET
ROUND SCREW M8 x 1.25 x 20mm
WASHER M8 x 2mm
5SSB40A 1
INSTALLATION ADDENDUM
1
2
3
4
Items 3 and 4 will
not be used in this
Addendum

Please review these installation options:
Single Stud Attachment:
When attaching the Adapter to a single stud, install three
Lag Bolts {17} included with MantelMount into the three
vertical holes in the center of the Adapter.
Always ensure the Lag Bolts are installed directly in the
center of the stud.
Post or Beam Attachment:
When attaching to a large vertical post or horizontal beam,
you can choose to install four {17} Lag Bolts into the four
holes at the corners of the Adapter.
Never install Lag Bolts too close to the edge of wood
material, make sure there is at least one inch of extra
wood outside of the Lag Bolts
3 center
Lag Bolts
Third Lag Bolt
Safety Bolt
Accessible
upper hole
Accessible
lower slot
4 corner
Lag Bolts
PAGE 2 MantelMount SSB40A Wall Adapter Addendum
Single Stud Installation: Only two Lag Bolts are accessible when the Lifting Mechanism {35} is in the
UP position. Install one Lag Bolt in the top hole and one Lag Bolt in the bottom slot. Then pull the Lifting
Mechanism down and install the Safety Bolt according to the Installation Manual. Install the third Lag
Bolt after the Lifting Mechanism is safely locked in the lowered position.