Manufacture Royale Opera User manual

INSTRUCTION FOR USE AND
SETTINGS
Opera

We congratulate you on the purchase of your
timepiece and thank you for your confidence in
us.
We hope that it will bring you great satisfaction.
Your Manufacture Royale timepiece requires
regular maintenance, which will allow you to
guarantee its longevity.
It is recommended to carry out a full service
every 3 to 4 years for a watch with mechanical
movement, automatic or manual winding.
We recommend that you read the instructions
for use, which will provide you with the
necessary information for optimal use of your
watch.
Precision object
Our master watchmakers have paid the
greatest attention to the assembly and
adjustment of your watch. Its precision is
subject to the influence of earth's attraction,
magnetic fields, shocks, as well as the ageing
of oils. If you notice any discrepancies in the
rate of movement, we recommend that you
have your timepiece tested by your authorized
Manufacture Royale partner, who will take care
to do whatever is necessary to ensure the
accuracy of your watch.

SETTING THE TIME
Winding (position 0)
The winding is carried out by turning
the crown clockwise. The movement is
fully wound when the crown is blocked.
Be careful not to force beyond the
blockage as you will damage the
movement. Your timepiece has a
power reserve of 108 hours, but we
recommend that you wind it up daily to
ensure optimal operation.
Setting the time (position 1)
It is necessary to pull the crown (C) to the
right in order to place it in position (1)
The setting is made by turning the crown
clockwise until the desired hour and
minutes are displayed. When the
operation is complete, push the crown
back to position

a
b
_______________ DEPLOYMENT OF THE RESONANCE CAGE _______________
It is necessary to press and hold the
deployment lock (A) of the Opera located
at 9 o'clock on the bezel and then open
the case by grasping it from above and
gently pulling it.
__________________ TRIGGERING THE MINUTE REPEATER __________________
The trigger (B) of the Opera located at 9
o'clock on the bezel allows the minute
repeater mechanism to be armed. To do
so, it must be pulled to the full towards 11
o’clock and then released. Once the
hours, quarters and minutes have been
rung, allow the mechanism to fully
discharge for at least 30 seconds.
.
Be careful never to lift the lock of the
minute repeater (B) in position (1) when the
winding stem (C) is pulled into position (1).

_________________ MOVEMENT CHARACTERISTICS ___________________
MR01 hand-wound mechanical movement
Diameter 32mm
Height 5,45mm
Number of components 319
Number of rubies 29
Power reserve 108 hours
Frequency 21’600 vibration hours
Display hours, minutes and minute repeater
________________________ WATER RESISTANCE ________________________
Your Manufacture Royale watch is water-resistant to 3bar/atm. It is
recommended to use your watch according to its waterproofing characteristics.
To protect the movement from moisture, make sure that the crown is always
pushed back against the case (position 1), especially after setting the time or
adjusting the functions if necessary.
CONTACT
For any request, please contact Manufacture Royale
[e-mail]

____________________ INTERNATIONAL WARRANTY ___________________
Conditions of Manufacture Royale International Warranty
The International Warranty below applies to Manufacture Royale brand products
sold or presented for repair under the warranty in all countries.
Your Manufacture Royale watch is guaranteed against any manufacturing defect
for two years from the date of purchase, on the following terms.
To be eligible for the 24-month International Warranty, Manufacture Royale brand
products must be purchased exclusively from authorized Manufacture Royale
dealers. Maintenance and repair work must also be carried out by an authorized
Manufacture Royale dealer. If these conditions are not met, no warranty claims
may be made.
Any part found defective due to a manufacturing defect duly noted by our
technical services will be repaired or replaced free of charge, at the discretion of
Manufacture Royale.
The Manufacture Royale International Warrranty is only valid if the warranty card
enclosed with the watch in its case is duly completed, dated, with the serial
number identified (on the back of your watch) and stamped and signed by the
authorized Manufacture Royale dealer who sold you your timepiece.
The following are expressly excluded from the Manufacture Royale International
Warranty:
- defects resulting from accidents, improper or abusive use or handling (such
as shocks, impact marks, crushing, excessive temperatures, strong
magnetic fields)
- unauthorized modification or repair
- the consequences of normal wear and tear and ageing of the watch, strap
and crystal
- loss of water resistance after two years from the date of purchase if your
watch is waterproof, any defect resulting from contact with water if your
watch is not waterproof.