Marquee 3M CANTILEVER UMBRELLA User manual

PART LIST
Lower cross bar Upper cross bar
Rotational Base Umbrella frame and canopy
Lower Pole
Base Cover
Screw Washer M8x16 M8
A x 1PC B x 1PC C x 1PC
D x 1PC E x 1PC
G x 8PCS I x 8PCS
3M CANTILEVER UMBRELLA
A S S E M B L Y I N S T R U C T I O N S

Fully tighten all
at this stage.
screws
A
B
C
D
F
open
close
H
H
I
I
Insert the base cover (F) over the lower pole (C) to
cover the rotational base (D). Then insert the frame
and canopy (E) into the lower base. Move the assembled
umbrella to your desired location and weigh down with
four concrete pavers. Your umbrella is now ready for use.
To open your umbrella, squeeze the handle and lift it up towards
the top of the umbrella pole. Release the handle to lock it into
position. Wind the crank clockwise until the canopy is fully open.
Do the reverse to close your umbrella again
To rotate your umbrella, step on the foot pedal and rotate the
frame and canopy to your desired position.
E
Use screw (H), washer (I) to fix the rotational base (D)
to the cross bar (A),(B), then use screw (H),washer (I)
to fix the lower Pole (C) to the rotational base (D)
A S S E M B L Y I N S T R U C T I O N S
Step 1
Step 2
Step 3 Step 4