Marshall Electronics SDI VIDEO DISTRIBUTION AMPLIFIER BD-0314 User manual

Marshall BD-0314
SDI VIDEO DISTRIBUTION AMPLIFIER
To operate unit, insert the power plug (Marshall V-PS6-1.2A)
into the power jack located on the rear of the unit and twist
the sleeve to lock the connector on. The unit is automatically
turned on when power is supplied to the unit and indicated
by the power LED on the front of the unit. Supply a
NTSC/PAL SDI video signal (SMPTE 259M) to the video
BNC connector labeled SDI IN.
Installing the hard mount brackets: Your BD-0314 comes
with two brackets that allow the unit to be hard mounted to
any surface with 4 screws. By removing the middle screw
on the enclosure, position the bracket and then replace the
screw. After both brackets are installed, place the unit in the
desired location and mark the holes using a pencil.
Each unit comes with 4 self-adhesive rubber feet to be
placed on the bottom of the unit to protect any surface that it
may be set upon. Available accessories include a space
saving stand that holds the unit in a vertical position or a rack
mountable face panel that holds multiple units in a 1U space.
For more information please visit www.LCDRacks.com.
Marshall BD-0314
SDI VIDEO DISTRIBUTION AMPLIFIER
To operate unit, insert the power plug (Marshall V-PS6-1.2A)
into the power jack located on the rear of the unit and twist
the sleeve to lock the connector on. The unit is automatically
turned on when power is supplied to the unit and indicated
by the power LED on the front of the unit. Supply a
NTSC/PAL SDI video signal (SMPTE 259M) to the video
BNC connector labeled SDI IN.
Installing the hard mount brackets: Your BD-0314 comes
with two brackets that allow the unit to be hard mounted to
any surface with 4 screws. By removing the middle screw
on the enclosure, position the bracket and then replace the
screw. After both brackets are installed, place the unit in the
desired location and mark the holes using a pencil.
Each unit comes with 4 self-adhesive rubber feet to be
placed on the bottom of the unit to protect any surface that it
may be set upon. Available accessories include a space
saving stand that holds the unit in a vertical position or a rack
mountable face panel that holds multiple units in a 1U space.
For more information please visit www.LCDRacks.com.