Marshall Electronics M-LYNX-10W User manual

Marshall Electronics
Broadcast A/V Division
User Manual
M-LYNX-10W
Marshall Lynx LCD Monitor
V.1.1
Please read this manual thoroughly before using the product
and keep it for future reference.

M-Lynx-10W LCD Monitor User Manual
LynxLynx
www.LCDracks.com
Marshall Electronics
2 3
Thank you for purchasing our product. To enjoy all the features of this product
and keep it in good condition, please read this manual thoroughly and follow the
instructions herein accordingly.
1. No parts of this product can be repaired by the user himself. In case
of faults, shut off the power immediately and consult us or our dealers.
As this product is made of precise electronics components, unauthorized
detachment or reassembly may damage it.
2. Do not expose this device to moisture, dirt, smoke, vapor or direct sunshine.
3. Unplug the monitor from the wall outlet before cleaning. Do not use
thinner or other chemical cleaner to clean this device.
Please use only a soft, damp cloth.
4. Keep the monitor far from extremely hot or cold places.
The storage temperature of this device is -20°C -+ 70°C
5. Avoid dropping or bumping this device.
6. Slots and openings in the monitor’s cabinet are provided for ventilation
and ensure reliable operation of the monitor and to protect it from
over-heating. These openings must never be blocked. The monitor
should never be placed near or over a radiator or head register. This
monitor should not be placed or built in to a rack or bookshelf unless
proper ventilation is provided and supplier instructions have been
adhered to.
7. Do not attempt to repair this monitor yourself by opening or removing
covers. This may expose you to dangerous voltage or other hazards.
 Refertoaqualiedservicetechnicianifservicingisnecessary.Ifmonitor 
is opened by anyone other than a factory authorized service center, the
warranty is voided. If serial number is removed or tampered with, the
warranty is voided.
8. When part replacement is required, make sure it is performed by a
 qualiedtechnicianandthatthepartsaresupportedbythemanufacturer.
M-LYNX-10W SPECIFICATIONS
• Westronglyrecommendhavingaqualiedtechnicianormaintenance
engineer install this device.
• Whenconnectingtothecomputer,setupthemonitortoVGAinput,
800 x 600 or 1024 x 600 (60Hz). Apply same settings to computer.
• WhenconnectingtoHDMI,setupthemonitortobeHDMIinput.
• Improperinstallationofthismonitormaycausebattery
leakage or short circuit.
When environmental temperature declines dramatically, dew may occur
inside the monitor. Wait for the moisture to evaporate. Then the device will
return to normal working condition.
If you have any questions about this device, please consult your
dealer.
INSTALLATION
MOISTURE
Type: TFT LCD Digital Panel
Screen size: 10-inch
Denition: 1024(h)xRGBx600(v)
Computer Resolution: 800 x 600 or 1024 x 600 (60Hz)
Inputs: HDMI,VGA,Composite
System: NTSC/PAL
Nominal Voltage: 12V
Power Consumption: 5WMAX
Control: Front panel button/Remote control
Operating Environment: -10ºC - +60ºC

M-Lynx-10W LCD Monitor User Manual
LynxLynx
www.LCDracks.com
Marshall Electronics
4 5
Precautions for remote control
• Donotplacetheremotecontrolindirectsunlightorclosetoheatsource.
High temperature many deform the remote control.
• Whenparkingyourvehicleinthesun,pleaseplacetheremotecontrolin
the glove compartment or other safe place.
• Whenexposedtodirectsunlight,thesignalemittingfromtheremote
control may not be properly received by the monitor. It should be placed
closer to the inductor on the front panel.
LCD Screen
• DonotpresstheLCDscreen.ItwillcausedistortionordamagetheLCD.
• Cleaningprecautions:
ADDITIONAL INFORMATION
• Useasoft,dampclothtocleanthescreen.
• Donotusesolventsuchasgasoline,thinner,cleaneroranti-static
spray to clean the screen.
• Donotusethisproductwhenenvironmentaltemperatureislower
than -10°C or higher than 60°C.
• Staticblueorredspotmayappearonthemonitorcalledalightspot.
It is a common phenomenon on any LCD. An LCD is a very precise
device, more than 99.99% segment is normal but less than 0.01%
 segmentmaybeaaw.However,thiswillnotaffectthefunctionof
the monitor.
CONNECTION

M-Lynx-10W LCD Monitor User Manual
LynxLynx
www.LCDracks.com
Marshall Electronics
6 7
In normal conditions, the battery has 1 year of life (shorter depending on
operating conditions). The lower the battery power, the shorter the operating
time.
Precautions for lithium battery
• Pleasekeepthebatteryoutofreachofchildren.Ifachildswallowsthe
batteries, consult a doctor.
• Cleanthebatterieswithadryclothtoensuregoodcontact.
• Makesurebatteriesareinstalledproperly.
• Donotuseametalclamptoclipthebatteries.Itmaycauseashortcircuit.
Warnings
If improperly handled, the batteries may explode. Do not charge the
batteries,destroythemorexposetore.
Installation Procedures of batteries:
• Takeoutbatterycard:pressdownthecardboltandpulloutthebattery
card.
• Replacethebatteries:installthebatterycardwithanodeupward.
• Insertbatterycard:insertthebatterybardintotheoriginalplace.
BATTERY INSTALLATIONFRONT PANEL BUTTON FUNCTIONS
/HDMI
MODE SELECT
When connecting to HDMI .set up the monitor to be HDMI input.
Menu
1.16:9/4:3
2.UP/DOWN/LEFT/RIGHT
3.VOLUME-
4.MENU
5.VOLUME+
6.AV1/AV2/VGA/HDMI
(INPUT SOURCE)
7. POWER
1. Power
2.AV1/AV2/VGA
3. Function Decrease
4. Reset
5. Function Increase
6.Menu(Up/Down/Left/Right)
1 2 3 4 5 6 7
REMOTE CONTROL OPERATIONS

Marshall Electronics, Inc.
Tel: [phone] • Fax: [phone]
www.LCDracks.com
[email protected]