Martelli THE SEWING ESSENTIAL TABLE User manual

THE
SEWING
ESSENTIAL
TABLE Assembly Guide
Martelli
Enterprises
proudly
presents

2
Attach side panels A&B to Center Brace using the screws
provided with Sewing Essential Table.
Screw leveling feet as far as
they will go into side panels.
Once the Sewing Essential
Table is completely assembled,
you may then adjust them as
needed in order to level out
your table.
1
– Getting Started –
What you will need :
•#3 Phillips Head Screw driver or drill bit •someone to help if possible
Hardware provided :
•4 leveling feet
•24 screws (22 will be needed)
•1 ringed pin
•Center Brace
•Side Panels A&B
•Aprons C&D
x4 x24 x1
SEWING ESSENTIAL TABLE
Assembly Directions
x1
x1
x1
Side Panels
not pictured

3
4
Adjust side panels to 30°
and tighten down knobs.
Attach Apron D to the rear
of the side panels with
screws provided.The letter
D should be facing outward.
Loosen knobs and adjust angle to a at 0°.
Retighten the knobs and insert ringed pin
at the 0° hole.
Attach Apron C to the front of the side
panels with screws provided.The letter
C should be facing outward.
Lower the table top into position with the ruler slot over Apron C.
Fasten table top into place with screws provided.
5

Martelli Enterprises
•
5450 North W Street
Pensacola, FL 32505
•
850-433-1414
•
www.martellinotions.com