MAST Title Bed 02 User manual

Title Bed 02
Assembly

Corner Bracket x 2 Cam Bolt x 4
Cam Hex Key Bolt Hex Key 45mm Bolt x 2 16mm Bolt x 16
The interlocking joinery of the Title Bed range has been designed with
ease of assembly and longevity in mind. With the addition of high
quality hardware, Title Beds can be assembled, disassembled and
used without any affect on the structural integrity.
We recommend two people to assemble a bed. Assemble the bed on
a soft surface ie. carpet, soft blanket etc. All hardware and tools are
supplied.

Step 1:
Step 2:
Insert the support
leg into the
underside of the
centre rail. Slot the
centre rail in to the
centre notch of each
leg rail. No fixings
required.
Slot the outside rails
into the the leg rails.
Ensure the threaded
inserts are at the
head end and are
facing in.

Step 3:
Step 4:
Attach the corner
brackets at the head
end using the 16mm
bolts provided. Use
the two 45mm bolts
through the top of
the rails at the foot
end. These should
be tightened to a
‘snug’ fit and not
over tightened.
It is best to lift the
bed frame into its
final position at this
point.
On a soft surface
lay out the platform
side rail and short
rail. Push together
and use the cam
bolts to tighten the
parts together.
These should be
tightened to a ‘snug’
fit and not over
tightened.

Step 5:
Step 6:
Attach the platform
rails to the bench
using 2 x Cam Bolts.
Flip the platform
over and place it in
the bed frame. No
fixings are required.

Step 7:
Place the mattress
slats in the platform
frame. No fixings
are required.