C
NEX-LEVEL®LADDER
Assembly & Installation
3
WHAT YOU NEED 1
2
+ Bolt Nex-Level Mounts onto platform with
open sides of the mounts facing inward
toward blind
+ Tools/supplies you’ll
need: 9/16” socket, 8
lag bolts, 4x4 lumber cut
to desired height (legs),
drill, and 2x4s with screws
(ladder rungs)
Before installing the
Nex-Level®Ladder System,
determine the location of
your blind’s door.
+ On your Nex-Level Floor Base outer frame,
remove the two existing framing bolts
and nuts closest to where your blind door
will sit
+ Position ladder system on frame and re-install
and tighten bolts and nuts
+ Make sure ground is level
+ Use 9/16” socket driver to lag screw
4” x 4” wood posts into open end of
Nex-Level mounts
+NOTE: It may be helpful to install a
temporary ladder rund to hold leg
spacing in the next step
x2
x8
Page 1/2www.MaverickHunting.com
4+ Make sure platform frame and ladder legs are
level and secure
+ If they aren’t, level and secure them before
moving on to the next step
08/22
Not Supplied
Lumber, Screws
8
24
6
PICTURES
NOT TO SCALE
AB
A
B B
