Maxtrix Daybed User manual

page 03
STEP BY STEP ASSEMBLY INSTRUCTIONS
IMPORTANT - READ CAREFULLY
RETAIN FOR FUTURE REFERENCE
is a registered trademark of Maxwood Furniture Inc.
Address: 675 E. Washington, Ave Bridgeport, CT 06608, USA
Bunk Beds comply with EN 747:2007 and Daybeds (Low/ Single bed) comply with BS8509:2008
Single beds are suitable for children ages 4 years and older.
Loft beds and Bunk beds are suitable for children ages 6 years and older.
Single beds should be placed up against the wall – or have a gap of at least 300mm between the wall and
the side of the bed.
More and important safety instructions in the back of this assembly instruction.
PRE-ASSEMBLY PREPARATION
Please check the pack contents before attempting to assemble this product. A full checklist of components is given
in this leaflet. If any components are missing, please contact your nearest stock list.
The ladder of bunk bed can be assembled on both left and right side, this instruction shows assembling for right
side.
This product takes approximately 120 MINUTES to assemble with 2 People.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG CHILDREN.
Read this leaflet in full before commencing assembly.
You will require a crosshead screwdriver, an Allen key (hex wrench) and perhaps a rubber mallet.
IMPORTANT SAFETY NOTE
Items must be assembled by an adult
Not suitable for children under 36 months due to the risk of falling
Do not leave children under 36 months un-attended
Always lift the unit from the base when moving it, do not drag along the ground.
It is recommended that two people should move the unit, never move it alone.
A hex wrench (5mm), drill bit (5mm) is supplied with this product. Additional tools needed to assemble this
bed/bunk bed incl. a crosshead screwdriver and perhaps a rubber mallet. If a power drill is used, please use in
lowest power setting as this otherwise may damage the product.
If any hardware parts used for assembling the bed are missing, please do not use replacement parts from other
suppliers, but contact an authorized Maxtrix®retailer for replacement parts.
It is recommended to put the slide on a carpeted floor. Do not use on hard surface, uncarpeted floors or tiled floors.
Children are likely to play, bounce, jump and climb on beds, therefore a child’s bed should not be placed too close
to other furniture or windows, and should be placed either tight to any wall or have a gap of 300mm between the
wall and the side of the bed.
WARNING. Do not place this child’s bed near heat sources, windows or other furniture.
WARNING. Do not use this child’s bed if any part is broken, torn or missing.