PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
MFI2266AE
Electrical: A 115 Volt, 60 Hz., AC only 15- or 20-
amp fused, grounded electrical supply is required.
It is recommended that a separate circuit serving
only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use
an extension cord.
NOTE: Before performing any type of installation,
cleaning, or removing a light bulb, turn the control
(Thermostat, Refrigerator or Freezer Control,
depending on the model) to OFF and then
disconnect the refrigerator from the electrical
source. When you are finished, reconnect the
refrigerator to the electrical source and reset the
control (Thermostat, Refrigerator or Freezer
Control, depending on the model) to the desired
setting.
Water: A cold water supply with water pressure
between 35 and 120 psi (241 and 827 kPa) is
required to operate the water dispenser and ice
maker.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the system needs to be a minimum of
approximately 40 to 60 psi (276 to 414 kPa).
IMPORTANT: The pressure of the water coming
out of a reverse osmosis system going to the
water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 12828181B
08-15-08
D
overall
C
top of
cabinet
B
not incl.
handle
incl.
handle
A
E
Model # Depth Cab. Width Cab. Height Overall Height Depth
"A" "B" "C" "D" "E"
MFI2266AE 31-7/8" 32-5/8" 68-5/8" 70-1/8" 34-1/4"
(80.98 cm) (82.88 cm) (174.31 cm) (177.12 cm) (87 cm)
To ensure proper ventilation for your refrigerator, allow for 1⁄2" (1.25 cm) space at
the top and behind the refrigerator. When installing your refrigerator next to a fixed
wall, leave 3-3/4" (9.5 cm) minimum on both sides to allow for the doors to swing
open. If your refrigerator has an ice maker, allow extra space at the back for the
water line connections.
NOTE: Do not install the refrigerator near an oven, radiator, or other heat source,
nor in a location where the temperature will either fall below 55°F (13°C) or rise
above 110°F (43°C).
French Door Refrigerator
3-3/4" (9.5 cm)
1/2"
(1.25 cm)
