Mcube HFX micro M2 User manual

HFX®is a trademark of mCubed Information Technology GmbH. The design is patented. 3D Visuals and product design by 24H Product Design.
www.hifiatx.com - offi[email protected] - mCubed Information Technology GmbH - Mollardgasse 85a/3/136 - 1060 Vienna - Austria
Please open first the 4 screws of the backpanel,
then you can lift up the lid.
Remove the DVD and HDD cage.
Lift and pull the base sheet.
Put the slim slot-in optical drive on the cage.
1 2
3 4
5 6
and attach the heatpipe adapters to the outer
heatsinks.
Turn the base sheet of the cage with the drive
around, and use the two shorter M2,5 screws to
fasten the optical drive to the base sheet
Screw the two longer M2,5 screws to the base
sheet, and use the nuts to fasten them They will
be used later to mount the card reader.
HFX®micro M2 - Installation Guide
7 8
For mounting the 2.5” HDD you have to prepare
the small plate with the hexagonal bolts. You
should use the longer bolts by standard. Only if
you want to install a thicker HDD, then please
use the shorter bolts. Use the counter sunk head
screws for fastening the hex bolts.
Place your Harddisk on the plate, on the side
without the hex bolts, and use the short screws
to fasten it. Depending what harddisk your are
installing different holes should be used.

You can mount the backpanel first by letting a
distance for closing the lid. After closing the lid,
please tighten the 4 screws of the backpanel.
Put the inner cage back into the case and put the
acrylic glas on the optical drive. Make sure to fas-
ten the screw holding the small acrylic part on the
heatsink. Push the small acrylic part on the heat-
sink down while fastening the screw.
Connect the front LEDs with the motherboard:
red front LED (yellow + / red -)
green front LED (black + / white -)
HFX®is a trademark of mCubed Information Technology GmbH. The design is patented. 3D Visuals and product design by 24H Product Design.
www.hifiatx.com - offi[email protected] - mCubed Information Technology GmbH - Mollardgasse 85a/3/136 - 1060 Vienna - Austria
910
15 16
Use three screws to mount the small plate and
HDD to the base sheet of the inner cage. Put the black plastik spacers on the screws for
the card reader.
A HDD silent box can also be placed on top of the
inner cage if the TV card is not too long. But there
is only space for 1 single HDD or HDD silent box.
The “Sens” connector is not needed, but the au-
tomatic front connector detection has to be deac-
tivated in Windows.
Take the cardreader out of its cage and use two
small threads to fix it to the inner cage. Plug in the
USB cable to the cardreader.
11 12
13 14