C
C
C
A
A
A
B
B
B
UPFOLDING THE LAPTOP STAND NOTE
4 5
C
C
A
A
A
B
B
B
C
Step 1:
Press and hold the button on Joint A to
rotate the lower leg until it reaches the
desired angle. The button will bounce back
out if the lower leg has been locked in place.
Step 2:
Press and hold the buttons on Joint B to
rotate the middle leg until it reaches the
desired angle. The button will bounce back
out if the middle leg has been locked in
place.
Step 3:
Press and hold the button on Joint C to
rotate the upper leg until it reaches the
desired angle. The button will bounce back
out if the upper leg has been locked in place.
• DO NOT place a laptop on the unit until you make sure all the legs and
the laptop tray are locked into place.
• Please make sure you have both sides locked at the same angle.
• If you need to readjust the angle of the laptop tray or legs, please refer to
the steps in Unfolding the Laptop Stand
• Please hold the laptop tray using your fingers if you try adjusting legs on
both sides at the same time.
•
If you fail to rotate the leg, please make sure you push the button deep in.
• Adjustments should go from lower leg, to middle leg, to laptop tray when
unfolding the unit; when folding the unit, they shot be done in the reverse
order (laptop tray middle leg lower leg)
• Max weight capacity is 33 Ibs. (15kg). DO NOT overload!
INSTALLING THE MOUSE TRAY
1. Slide the washer onto the star knob.
2. Place the laptop stand with its front lip
facing you.
3. Put the mouse tray on the right side of the
right upper leg and line up their holes.
4. Screw the knob through the holes.
UPFOLDING THE LAPTOP STAND
Step 1:
Press and hold the button on Joint C to
rotate the upper leg so it sits even with
the laptop tray.
Step 2:
Press and hold the button on Joint B to
rotate the middle leg so it sits even with
the upper leg.
Step 3:
Press and hold the button on Joint A to
rotate the lower leg so it sits even with
the middle leg.
1. Attach an edge stopper to the
front lip of the laptop tray, fitting
its groove over the lip. (The flat
side of the stopper should sit on
the tray.)
2. Rotate the stopper to 90 degrees.
