Medusa MS-350 User manual

1
Assembly
instructions MS-
350/700/1000 drone
mount for DJI M-600

2
Manual version: V1.0
Manual date: 05-08-2022
Medusa Radiometrics
Skagerrak 26
9723 JR Groningen
Netherlands.
Tel: [phone]
Mail: [e-mail]
http://www.medusa-radiometrics.com/

3
Introduction
We have made a special drone mount for use under M-600
drones. These drones normally come with a mounting frame
that can be used to attach your gear (see images below). The
following steps will explain how to mount your sensor.

4
Parts provided by Medusa
Medusa provides the 4 aluminium parts and bolts needed to
connect the handle to the drone mount.

5
Parts from M-600
The M-600 normally comes with a frame shown in the picture
below. Sometimes the frame comes in a dissembled form.

6
Step 1. Prepare the M-600
mounting frame
Screw off two of the black feet (see the image below).
Then remove a black rod on the two black carbon rods.
Continue with the mounting instructions of the Medusa Parts
mentioned below.

7
Step 2. Mounting the
Medusa parts
Put the 2 short Aluminium plates onto the carbon rods with
the cut-outs facing down (see image on the left). And move
the black rod towards the middle of the M-600 mount. This
will secure the aluminium plates.
Then position the other two (long) plates to join in the cut-
outs shown in the picture on the right. And move the black
rod towards the middle of the M-600 mount. This will secure
the aluminium plates.

8
Move the second black rod
from the other side towards
the aluminium plates and
tighten the screws to secure
their position.

9
Now put the remaining black feet back on the
M-600 mount.

10
Step 3. Mounting your
detector
Finally, attach the
mounting while turning it
upside down on the MS-
xxx handle and tighten
using the 4 M3 bolds. It is
advised to use Loctite to
secure these bolts.

11
Medusa Radiometrics
Skagerrak 26
9723 JR Groningen
Netherlands.
Tel: [phone]
Mail: [e-mail]
http://www.medusa-radiometrics.com/