Meek M7110 User manual

Owners Care Manual
M7110
Check out some of our other products
Meek Mirrors
6201 S Zero Street PO Box 11200 Fort Smith, AR 72903
PH: 800-643-2533 FX: 479-646-6231
[email protected]
M4300 / M4400
Fixed Tilt Mirrors
M1100/1200
Angle Frame Mirrors
To see Meek’s other mirror styles , shelves and
restroom accessories visit our website!
www.meekmirrors.com

Cleaning Instructions:
1. The best and safest cleaner for a mirror is clean, warm water used with a soft,
lint-free cloth. Be careful to not allow the edges of the mirror to become wet over a
period of time.
2. Never spray any cleaner directly onto the mirror. Instead apply the cleaner to the
soft cloth and then wipe the mirror. This will also prevent “puddling” at the mirror
edge where the cleaner could attack the backing.
3. If that does not work, use commercial cleaner that does not contain ammonia,
vinegar, acid or alkali cleaner. All of these can attack the surface edges and back
of the mirror resulting in black edge.
4. Do not use acid or alkali cleaners for the mirror after installation. They can attack
both the surface and the edges of the mirror. And NEVER use abrasive cleaner on
any mirror surface.
5. Remove any surface marks or stubborn dirt with 0000 oil-free steel wool,
not solvents. Solvents attack and damage edges and backing.
6. Always use soft grit free cloths when cleaning a mirror to reduce chances of
scratching the surface.
7. Be sure to dry all joints and edges thoroughly to be certain that no commercial
cleaner comes in contact with the edge and backing.
Warranty Information:
NOTE: Improper Cleaning or Installation will void the warranty.
Visit our website to view full warranty information
or scan the QR code on your smart phone.
QR Code Reader:
QR Code Readers can be downloaded to any IPhone or Android Phone.
For IPhone users: go to the App Store on your phone and search QR Code Reader.
For Android users: go to your phones Google Play or Android App Store and
search for QR Code readers.
Installation Videos:
Visit our website www.meekmirrors.com to view our installation videos
*Scan the QR code to view them on your smart phone*
Installation Instructions:
1. Install wall plate on wall. Fasten all four corners using the pre-drilled holes.
Recheck to make sure wall plate is square and level.
2. Center framed mirror over the wall plate slide the mirror completely down on
the lugs. Check all four corners to ensure they are fastened to the wall plate.
3.Pull string toward the right corner to engage the security lock. After the final
inspection, cut and remove the string.
4.To remove mirror: insert putty knife at the bottom right side and push the security
lock back to the left. Lift up and remove.