METHVEN Aurora 14-1708 User manual

Laser Shower Rail
and Soap Dish (where provided)
Installation Guide
Use of this product in non-domestic applications voids warranty.
IMPORTANT
Please read all of the instructions before installation
Laser Shower Rail
and Soap Dish (where provided)
Installation Guide
Use of this product in non-domestic applications voids warranty.
IMPORTANT
Please read all of the instructions before installation

Installation
1. Establish the desired Rail position and height.
2. Mark the drilling hole positions on the wall at 620mm centres.
3. Drill both holes to suit fixing anchors provided.
4. Carefully remove the rail pillars’ end caps.
Note: One pillar has an internal knob to match the notch in the rail end.
Mount this pillar at the top.
5. Attach the top pillar to wall using anchor and screw.
6. Check the handset slider/holder and soap dish (where provided)
are on the rail.
7. Fit the rail (notched end to the top) and bottom pillar to the fixed
pillar and attach the bottom pillar to the wall.
8. Click on the soap dish at the required position on the rail.
9. Replace the push-in end caps.
97-9332
SEPT 2009
Installation
1. Establish the desired Rail position and height.
2. Mark the drilling hole positions on the wall at 620mm centres.
3. Drill both holes to suit fixing anchors provided.
4. Carefully remove the rail pillars’ end caps.
Note: One pillar has an internal knob to match the notch in the rail end.
Mount this pillar at the top.
5. Attach the top pillar to wall using anchor and screw.
6. Check the handset slider/holder and soap dish (where provided)
are on the rail.
7. Fit the rail (notched end to the top) and bottom pillar to the fixed
pillar and attach the bottom pillar to the wall.
8. Click on the soap dish at the required position on the rail.
9. Replace the push-in end caps.
97-9332
SEPT 2009