METHVEN Indra INBFCPUK User manual

Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Care and Cleaning:
439862 ISSUE A www.methven.com
Technical Specifications:
Operating Pressure:
Min: 30kPa/0.3bar
Max: 1000kPa/10bar*
Optimum: 150kPa/1.5bar - 500kPa/5bar
Operating Temperature:
Hot: Max 70°C*
Cold: Min 5°C
Inlet Connections:
All ¾" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
BATH FILLER
Installation Guide

•
Step 1
Insert base ring seals into the grooves in
the bottom of the base rings.
Place the base rings over the holes in the
bath ensuring that the seals remain in
place.
Feed the mixer inlet tubes through the base
rings and bath holes, and position the
mixer where required.
IMPORTANT: Before you begin, turn off the water supply.
•
Step 2
Fit the mounting washers and mounting
nuts onto the inlet tubes from under the
mounting surface.
Tighten the mounting nuts to secure the
mixer in position.
•
Step 3
Flush all pipe-work thoroughly prior to the
next step.
Connect mixer inlet tubes to hot and cold
supplies ensuring a good seal at each joint.
Leak test installation.
The seal integrity of pipe joins are the
responsibility of the installing plumber.
•
•
•
•
•
28mm min
180mm
35mm max
Base Ring Seal
Base Ring
Mounting Washer
Mounting Nut
•
•
•
•
IMPORTANT: Please read all of the instructions before installation.
General:
Methven recommends this product is installed by a licensed plumber in compliance with all
relevant regional regulations.
Do not hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridges may occur.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
Do not remove the ceramic cartridges from the mixer when installing.
After installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per
regional regulations.
This mixer is not recommended for use in uncontrolled heating systems such as wet-backs or
solar heating units unless a suitable tempering valve is fitted.
If limited water flow is experienced, locate aerator and filter washers and clean away foreign
material as required.
It is the responsibility of the installer to ensure a waterproof seal is achieved between the
product and mounting surface. If in doubt about the quality of the seal, remove the product and
reinstall using silicone to ensure a seal is achieved.
•
•
•
•
•
Hot Cold