METHVEN SATINJET User manual

www.methven.com
SATINJET®OVERHEAD SHOWER/ARM
Installation Guide
Technical Specifications:
Operating Temperature:
Hot: Max 60°C*
Cold: Min 5°C
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
Inlet Connections:
All ½" BSP
Operating Pressure:
Min: 35kPa/0.35bar
Max: 500kPa/5bar*
Optimum: 35kPa/0.35bar
- 500kPa/5bar
Operating Pressure:
Min: 35kPa/0.35bar
Max: 500kPa/5bar*
Optimum: 35kPa/0.35bar -
500kPa/5bar
SHOWER ARMS OVERHEAD SHOWERS

•
IMPORTANT:
Please read all of the instructions before installation.
GENERAL:
•
•
This product must be installed in compliance
with all relevant regional regulations.
It is the responsibility of the installer to
ensure a watertight seal is achieved.
All outlets used primarily for personal hygiene
shall deliver water at a safe temperature as
per regional regulations.
Some showers may not provide an effective
shower when used with gravity fed heated
water systems or where pressures are less
than 150kPa/1.5bar at the outlet. Additionally
showers with flow rates of less than 9L/min
may not allow the following to function
correctly:
· Some instantaneous water heaters
· Some tempering valves
· Some thermostatic mixing valves
Methven Satinjet
Overhead Shower
(If Supplied)
NOTE: Use plumbers tape or similar on ¹⁄₂" male
threaded connection to ensure a reliable seal.
Filter Washer
Arm
(If Supplied)
Trim Ring
Min 10mm
Max Ø 25mm
CARE AND CLEANING:
• Never use abrasives or abrasive cleaning agents to clean this product. To clean the chrome-plated
surface use contamination free warm soapy water and a damp soft cloth.
• Lime deposits can be prevented from forming on the faceplate by wiping immediately after use. If
shower performance is compromised by the build-up of lime-scale, soak in limescale remover for up
to 10 minutes. Do not attempt to remove limescale with sharp objects or abrasives. Do not use
products containing chlorine bleach or hydrochloric acid as these can damage the shower. Always
rinse the shower thoroughly after cleaning to remove cleaning products that can damage the shower.
• Clean face plate using a brush with soft bristles.
• Do not use any sharp objects to clean nozzles.
• Clean filter washer located in the ball joint periodically.
439937 ISSUE C