Micron Prime Pod Mini Installation instructions

1
Micron Prime Pod Mini
Hardware Guide
Expanded View……………………………………………………………………..2
Top/Bottom View………………………………………………………………....3
Quick Start Guide………………………………………………………………….4
SIM Card Installation……………………………………………………………..5
Battery Replacement…………………………………………………………….6,7
Hardware Guide

Mounting Bracket
Top Cover
Power Switch
Sensor Hole
Magnetic
Back Plate
SIM Card Tray LED
Expanded View
2
Hardware Guide

3
Hardware Guide
Top View
Bottom View
LED Indicator
Light Sensor Temp/Humidity Sensor

Open box and separate
mounting bracket from
device.
Connect top of bracket
with the slots on the back
of the device.
Twist the bracket
counterclockwise to
unlock the top cover.
Once unlocked, pull
cover off device.
Locate the power switch on
the side of the device and
slide it to the “ON” position.
Wait for the LED light to
turn on.
Use the USB C port located
on the side of the device
(under the ON/OFF switch)
for programming device
commands.
Put the cover back on the
device.
Use the bracket (step 1) to
twist the device clockwise to
lock it. 4
Quick Start Guide

Open box and separate
mounting bracket from
device.
Connect top of bracket
with the slots on the back
of the device.
Twist the bracket
counterclockwise to
unlock the top cover.
Once unlocked, pull
cover off device.
Locate the power switch on
the side of the device and
slide it to the “OFF” position.
Locate the SIM tray on
the top of the device.
Slide tray cover to unlock,
open and insert the new SIM
card with the gold contacts
facing down.
Close and lock the SIM card
tray by sliding it forward,
then turn on the device after
installing new SIM card.
Use the bracket (step 1) to
twist the device clockwise to
lock it. 5
SIM Installation Guide

.
Battery Replacement Guide
Part 1
Connect top of the
mounting bracket with
the slots on the bottom of
the device.
Once unlocked, pull cover
off the device.
Locate three small clips
holding unit in place. Push clips out, releasing
the device.
Pull component out of
case.
Twist counterclockwise to
unlock the top cover.
6

.
With the battery facing
up, unplug and pull old
battery out.
Align sensor hole on case
with sensor hole next to
battery, push component
back into place.
Component should align
with grooves on side of
case, push in until all
three clips (step 5) make a
clicking sound.
Plug device into a computer
using the USB C port and
send battery replacement
command (AT+GTRTO) via
Micron MAP Utility
program. Reset device after
command acknowledged.
Put the cover back on
device. Use the bracket
(step 1) to twist device
clockwise to lock it.
Connect new battery and
put into device.
11 12
Battery Replacement Guide
Part 2
7