Technical safety
~Before setting up the appliance,
check it for any external damage. Do
not install and use a damaged
appliance.
A damaged appliance may endanger
your safety! Contact the Miele Service
department.
~If the connection cable is damaged
it must be replaced by a Miele
approved service technician to protect
the user from danger.
~Safe operation of the appliance is
only assured if it has been installed and
connected in accordance with these
installation and operating instructions.
~Before plugging in the appliance,
make sure that the connection data
(voltage and frequency) indicated on
the data plate corresponds with the
electrical supply.
These data must match in order to
avoid damaging the appliance. If in
doubt, please contact a qualified
electrician.
~Do not connect the appliance to the
power supply by an extension cord or
power bar, as they do not guarantee
the required safety (risk of overheating,
for example).
~The electrical safety of this
appliance can only be guaranteed if it
is properly grounded in compliance
with all applicable local and national
safety regulations. It is very important to
ensure that this essential safety
requirement is met. If there is any doubt
about the grounding of your household
wiring, have it inspected by a qualified
electrician.
The manufacturer will not be held liable
for damages resulting from an
inadequate grounding system (e.g.
electric shock).
~Only professionals who are duly
authorized by the manufacturer may
install or perform maintenance and
repair work on this appliance.
Work performed by unqualified persons
harbors the risk of serious harm to the
user for which the manufacturer will not
be held liable.
~Repair of the appliance during the
warranty period should only be
performed by a service technician
authorized by the manufacturer,
otherwise any damage will not be
covered by the warranty.
~Disconnect the appliance from the
electrical power supply prior to
installation, maintenance or repair.
The appliance is disconnected when
one of the following conditions is met:
–the appliance has been unplugged.
To unplug, pull carefully on the plug,
NOT on the cord.
–the respective breaker of the house
wiring system is off.
~Defective components should only
be replaced with genuine Miele original
spare parts. Only with these parts does
the manufacturer guarantee that they
comply with the safety requirements.
~This appliance may not be used in
mobile sites (e.g. ships).
~The manufacturer will not be held
liable for damage resulting from a faulty
connection to the water supply.
Warning and Safety Instructions
9