Miele M 6040 SC User manual

Installation Instructions
M 6040 SC en - CA
Installation, repair and maintenance work should be performed by
a Miele authorized service technician in accordance with national
and local safety regulations and the provided installation instructions.

Disposal of packaging material
The cardboard box and packing
materials protect the appliance during
shipping. They have been designed to
be biodegradable and recyclable.
Ensure that any plastic wrappings,
bags, etc. are disposed of safely and
kept out of the reach of children.
Danger of suffocation!Ensure that any
plastic wrap is disposed of safely and
kept out of the reach of children.
Danger of suffocation!
Disposal of your old appliance
Old appliance may contain materials
that can be recycled. Please contact
your local recycling authority about the
possibility of recycling these materials.
Before discarding an old appliance
ensure that it presents no danger to
children while being stored for
disposal. Unplug it from the outlet, cut
off its power cord and remove any
doors to prevent hazards.
Caring for the environment
52

,CAUTION: Before servicing,
disconnect the power supply by
either removing the fuse, shutting off
the power main or manually
"tripping" the circuit breaker.
Installation work and repairs should
only be performed by a qualified
technician in accordance with all
applicable codes and standards.
Repairs and service by unqualified
persons could be dangerous and
the manufacturer will not be held
responsible.
Before connecting the appliance to
the power supply, make sure that
the voltage and frequency listed on
the data plate correspond with the
household electrical supply. This
data must correspond in order to
prevent machine damage. Consult
an electrician if in doubt.
Only operate the appliance after it
has been installed into cabinetry.
The appliance must be plugged into
an appropriate outlet that is installed
and grounded in accordance with
all local codes and ordinances.
Power supply
The microwave comes equipped with a
power cord with a NEMA 5-15 P
molded plug ready plug ready for
connection to a:
120 V, 15 A, 60 Hz power supply.
WARNING: THIS APPLIANCE
MUST BE GROUNDED
Installer:
Please leave these instructions with the
consumer.
53
Electrical connection

When building in the appliance,
ensure that the vents located at the
front of the appliance are not
blocked, and that there is adequate
ventilation to the rear of the unit
(see illustrations).
Do not block the ventilation gaps!
This microwave is suitable for
installation into a tall cabinet.
A minimum installation height of
33 7/16" (850 mm) must be maintained.
During transport be sure to lift the
appliance by the housing, not by the
frame. The framework is not sturdy
enough to support the weight of the
appliance while being carried.
Building-in dimensions
Tall cabinet
Installation
54
20
595
452,5
>850
3

Installation accessories
(supplied)
Only operate the appliance after it
has been installed into cabinetry.
^Mark the center line of the cabinet.
^Position the fitting bracket on the
center line. Use the mark on the
bracket as a guide.
Installation
55
4 x 16mm
3

^Fit a screw ain to the center of the
first long hole.
^Check the alignment of the unit, then
fit another screw ainto the other
long hole.
^Tighten both screws.
^Place the appliance in the niche.
Using both hands on the back of the
microwave interior move it into place.
The microwave will engage into
position once it is correctly installed.
^Check the alignment.
^If it is not aligned correctly, pull the
appliance out of the niche and
realign it by slightly adjusting the
bracket on the long holes.
^Once correctly aligned, to prevent
the unit from moving insert a third
screw ainto the middle of the
bracket.
^Slide the unit into the niche, pulling
the plug and cable through the back.
^Connect the electrical supply.
^Push the appliance all the way in to
the niche as described above.
Installation
56

57

58

59
9 Independence Way
Princeton, NJ 08540
Phone:
Fax:
www.mieleusa.com
U.S.A.
Miele, Inc.
National Headquarters
Please have the model and serial number
of your appliance available before
contacting Technical Service.
Canada
Importer
Miele Limited
Headquarters and Miele Centre
800-843-7231
609-419-9898
609-419-4298
Technical Service & Support
Nationwide
Phone:
Fax:
T
[email protected]
161 Four Valley Drive
Vaughan, ON L4K 4V8
www.miele.ca
800-999-1360
888-586-8056
Customer Care Centre
Phone:
[email protected]
800-565-6435
905-532-2272
Germany
Manufacturer
Miele & Cie. KG
Carl-Miele-Straße 29
33332 Gütersloh

M.-Nr. 09 798 350 / 01en - US, CA
M 6040 SC