Miele M 7244 TC User manual

11195170-01
Installation
*INSTALLATION*
When building in the appliance,
ensure that there is adequate
ventilation to the front of the
appliance.
Do not obstruct the air vents with
any objects.
Lifting the microwave oven by the
door handle could cause damage to
the door.
Use the handle cut-outs on the side
of the housing to lift the appliance.
Building-in dimensions
Dimensions are given in mm.
Tall unit installation
595
450
562
>550
_
+6
+2
Base unit installation
595
460
+2
>550
__
>550
_
>550
__
>550
_
>550
_
+6
562
_

11195170-01
Installation
*INSTALLATION*
Side view
455,5
451,5
333
111,5
22
22* / 23,3**
4min.2
* Glass
** Stainless steel

11195170-01
Installation
*INSTALLATION*
Tall unit connection
3
70
53
2
1
451,5
595
aFront view
bMains connection cable,
length=1,600mm
cNo connections permitted in this area

11195170-01
Installation
*INSTALLATION*
Base unit connection
3
70
53
2
1
451,5
595
aFront view
bMains connection cable,
length=1,600mm
cNo connections permitted in this area

11195170-01
Installation
*INSTALLATION*
Carrying out installation
The appliance must be built in before
it can be used.
Slide the appliance into the niche.
Feed the cable with the plug through
the back of the furniture unit.
Align the appliance.
Open the appliance door and secure
the appliance into the side walls of
the furniture unit using the screws
provided.

11195170-01
Installation
*INSTALLATION*
Electrical connection
Danger of injury due to a
defective appliance.
Before connecting the appliance,
ensure that it has not been damaged
in any way.
Do not use a damaged appliance.
The appliance is supplied with a power
cord and plug for connection.
Make sure that the earthed socket is
freely accessible at all times. If the
switch is not accessible after
installation an additional means of
disconnection must be provided for all
poles.
Risk of fire from overheating.
Connecting the appliance to a multi-
socket plug adapter or to an
extension lead can overload the
cable.
Do not use an extension lead or
multi-socket plug adapter.
Connect the appliance directly with
the original cable without any
intermediate elements.
The electrical system must comply with
the applicable standards and with local
and national regulations.
If the connection cable is damaged, it
must only be replaced with a specific
connection cable of the same type
(available from Miele) in order to avoid a
hazard. For safety reasons, such
replacement may only be carried out by
a qualified and competent technician or
Miele.
The connection data can be found on
the data plate located on the front of
the oven interior or on the back of the
appliance.
Compare the specifications on the data
plate with those of the mains electricity
supply. The data must match.
If in any doubt, consult a qualified
electrician.
The appliance must not be connected
to the inverter of an autonomous power
supply such as e.g. a solar power
system. When the appliance is switched
on, power surges could result in a
safety switch-off. This could damage
the electronics.
The appliance must not be used with
so-called energy saving devices either.
These reduce the amount of energy
supplied to the appliance, causing it to
overheat.