Miele Touchtronic W 1119 User manual

WTV 408 Stacking Kit Installation Instructions
W1119 Washer and T1329C Dryer Only
Warning!
Prior to installation or service disconnect the units by “tripping” the breaker,
unplugging the unit or removing the fuse.
Installation and service should be by a Miele authorized service technician.
Work by unqualified persons could be hazardous and may void the warranty.
Stacking Kit Shelf Removal (Fig. 1)
Fig.1
• Push the self in slightly to release.
• Pull the shelf out until it stops.
• Lift the shelf slightly; pull forward
and tilt downward to remove.
Washer Lid Removal (Fig. 2)
c
Fig.2
a
b
a
• Remove the 2 screw caps (a)
• Loosen the lid screws 5 turns. (b)
• Push lightly on the screws to
release the retaining clips.
• Lift the front of the lid and slide it
backwards to remove.
• Remove the 2 screws from the
rear lid brackets (c)
• Slide the brackets to the side and
remove.

Fig.3
a
Installing the Stacking Kit (Fig.3)
• After removing the washer lid, lay the
stacking into position on top of the
washer.
• Secure the stacking kit with the screws
provided.
o 2 screws with star washers in the
rear (a)
o 4 screws without star washers on
top.
Dryer Grille Replacement (Fig. 4)
• While supporting the door, remove the hinge
screws.
Fig.4
Fig.5
• Place the door to the side.
• Remove the screw caps from the dryer grille.
• Remove the screws and grille.
• Place the provided grille into position and
secure with screws.
• Install the screw caps
Note
T1329C door panels must be trimmed when
installing a stacking kit.
Custom panels must be 231/4”L X 231/4”H,
when installing a stacking kit on a T1329C
dryer.
Trimming the Dryer Door Panel (Fig.5)
• Remove the trim frame from the dryer door.
• Using a fine bladed jigsaw, cut 1 13/16” from
the bottom of the door.
• Using a hack saw, shorten the side trim by
1 13/16”
• Install the trim on the door.
• Install the door.

Dryer Installation (Fig. 6)
Note
Use caution when lifting heavy objects
• Adjust the dryer feet to ¾”
as shown. (a) ¾”
• Make sure the flat side of
foot pad faces forward. (a) aFig. 6
• Place the dry in the guides
of the stacking kit and slide
back into position. b
• Install the retaining brackets and secure
with the provided screws. (b)
• Install the end caps (c) and secure with
screws.
• Reinstall the shelf.
c