Before using for the first time
Packing materials
Remove all packing materials from
inside the appliance.
Protective foil
The external surfaces of stainless steel
appliances are covered with a
protective foil.
^Remove the protective foil only after the
appliance has been installed in its
intended location.
Cleaning and care
Please read the relevant instructions
in the "Cleaning" section of this
booklet.
^Immediately after removing the
protective foil, apply the Original
Miele Care product for stainless steel
(availabe from Miele or at
www.miele.com.au) to stainless steel
strips and frames.
^Also apply the Original Miele Care
product for stainless steel to the side
panels after removing the protective
foil.
Appliance doors have a special
coating that is not susceptible to
soiling. Do not apply this product to
doors.
Important! Each time the Original Miele
Care product for stainless steel is
used, it forms a protective film against
dirt and water.
^Clean the inside of the appliance and
the accessories with lukewarm water
and then dry with a soft cloth.
Active charcoal filters
(Active Air Clean charcoal filters)
^Place the active charcoal filters
supplied in the holder, and place the
holder on one of the shelves in the
PerfectFresh zone (see "Active
charcoal filters").
Operating the appliance
A light touch of the finger on the
sensors is all that is required to operate
this appliance.
Switching on
The PefectFresh zone and freezer
section are switched on together with
the On/Off sensor.
^Touch the On/Off sensor until the
temperature display lights up.
If the temperatures in the appliance are
not within the range that the appliance
is able to display, only bars will light up
in the temperature displays.
The "PerfectFresh" and the "Freezer"
symbols as well as the Alarm off sensor
will flash until the temperatures are
sufficiently low.
As soon as the temperatures are within
the range that the appliance is able to
display, the temperature display will
show the current temperature.
Switching on and off
19