Millar TC-510 User manual

World Headquarters
Millar Instruments, Inc.
6001-A Gulf Freeway
Houston, Texas 77023-5417 USA
Phone: [phone] or 800-669-2343 (in the USA)
Fax: [phone]
Email: [email protected]
Web site: www.millarinstruments.com
Millar Worldwide Distribution
Millar Instruments, Inc. has a network of Authorized Distributors in most countries around the world.
For information on the Millar distributor in your country, please contact the Millar Customer Service
Department at our headquarters in Houston.
European Authorized Representative
FMI Föhr Medical Instruments GmbH
In der Grube 13
D-64342 Seeheim/Ober-Beerbach
Germany
Telephone: [phone] - 96 22 60
Fax: [phone] - 96 22 62 + 8 20 17
Email: [email protected]
©2008 Millar Instruments, Inc. All rights reserved
Millar, Mikro-Tip and Sensors.Systems.Solutions. are registered trademarks of Millar Instruments,
Inc.
Products and company names used are the trademarks or trade names of their respective companies.
M.I. P/N: 004-1340 Rev. F
Sensors.Systems.Solutions.®
TC-510 Monitor Input Cable
Instructions for Use

1
Definition of Symbols
Attention, consult accompanying documents
Date of Manufacture
Catalog Number
Serial Number
Batch Code
EU Declaration of Conformity
Waste Electrical and Electronic Equipment
Device Description
Millar Instruments offers an assortment of TC-510 pressure control unit output cables for a variety of
monitors and recorders. An unterminated cable M.I. P/N: 850-3008 is offered for the user to wire
their connector for the appropriate input on their monitor.
Cleaning
Wipe the cable and connectors clean with a soft wet gauze or tissue. If extremely dirty, the cable may
be soaked in a solution of Alconox® or other mild detergent.
CAUTION: Do not immerse the electrical connector.
Routine Inspection
Conductive liquid entering the cable connectors can cause erratic operation and possible corrosion of
wires within the connectors. The connector pins should be routinely inspected for corrosion.
2
Millar Limited Warranty
Millar Instruments, Inc. (Millar) warrants all of its cables to be free from defects in workmanship and
materials at the time of shipment to the original purchaser.
Millar hereby excludes all warranties not herein stated, whether express or implied by operation of
law or course of dealing or trade usage or otherwise, including but not limited to any implied
warranties of fitness or merchantability.
Since handling, storage, cleaning and sterilization of the product, as well as factors relating to patient
diagnosis, treatment, catheterization procedures, and other matters beyond Millar’s control, directly
affect the product and the results obtained from its use, Millar shall not be liable for any incidental or
consequential loss, damage, or expense arising directly or indirectly from the use of this product.
Specifications subject to change without notice.
9 PIN D-SUB MONITOR
1
3
9
7
5
RED
BLACK
GREEN
WHITE
SHIELD
+
EXCITATION
- EXCITATION
+ SIGNAL
- SIGNAL
Cable Schematic