Millennium KONTI User manual

KONTI/AKEMI/CIOSO/KIATO
BATH FILLERS & BATH FILLERS
WITH HAND SHOWER
Important Information
•Hot and cold water inlet pressures should be equal.
• Maximum static water pressure is 500kpa - AS/NZS3500.1-2003(clause 3.3.4).
If water pressure exceeds 500kpa warranty is voided.
• Lines must be flushed out prior to installation of the mixer. Damage caused to the
mixer by copper filings/foreign matter coming through the pipework is not covered
under warranty.
•Maximum hot water temperature is 80C.
Cleaning Instructions
1. Under no circumstances should tapware be installed using acetone silicone
2. Never clean Mixers/Tapware/Showers/Accessories using harsh detergents/cleaning
products, citrus based cleaning products or abrasive cleaning pastes.
3. Where your tapware remains dry in use, a soft 100% cotton cloth can be used to remove
dust
4. Alternatively, wipe over with a soft 100% cotton cloth using tepid water with a small
amount of liquid soap added (2% liquid soap maximum). Using a different cotton cloth
thoroughly rinse off all soap mix using cold water. To finish wipe off all residual water with
another dry cotton cloth
GENERIC INSTRUCTIONS FOR INSTALLATION OF
MILLENNIUM BATH FILLERS & BATH FILLERS WITH
HAND SHOWERS ON CONCRETE FLOORS

INSTALLATION
IMPORTANT INFORMATION
Recessed measurements - Minimum 40mm with finished floor.
Min. 40mm
Step 1
Connect the inlet elbow (installer supplied)
to the concealed floor mount.
Step 2
Locate the floor mount on the floor. It must
be square to the edge of the bath with the
water inlet elbows located as per the
diagram.
CH
Bath
Step 3
Secure the floor mounts to the floor, ensuring
the mount is square and level to finished floor
(refer to levelling bubble on top plate).
Tighten.
Important!
Please ensure pressure test has been
conducted before moving onto Step 4.
Step 4
Using the allen key provided, remove the
levelling panel from the floor mount and pop
out level.
Ensure you put the screws in a safe place
to re-secure plate later.
Step 5
Slide flange onto the bottom of the mixer
column.
Secure the levelling plate to underside of
mixer column with screws provided.
x4
9mm

Step 8
Remove pressure test plugs from outlet holes
and push the long water pipes into to the
floor mount. Twist the entire mixer until the
holes of the levelling plate line up with the
holes in the floor mount.
Step 10
Slide cover flange over floor mount to
conceal.
INSTALLATION
Step 6
Screw both water pipes into the body of the
mixer, ensuring that the correct pipe is
connected to the correct inlet hole
(cold pipe & inlet is marked).
Make sure the o-ring is a tight fit and is not
damaged. If damaged, replace the o-ring
with spares provided.
Step 7
Screw the mixer body to the mixer
column, carefully feeding the water
pipes through the bottom.
Important!
Ensure hot and cold water tubes are
inserted into the correct sides.
Step 9
Secure the mixer to the floor mount
using the screws that were removed
earlier. Tighten.
x4
14mm
Step 11
For models including a hand shower
connect hose to hand shower and outlet
and place hand shower into holder.