Mimosa SIGNATURE EDEN User manual

YEAR
W
A
R
R
A
N
T
Y
W
A
R
R
A
N
T
Y
3
ASSEMBLY INSTRUCTIONS
Pre-Bled to Minimise Tannin Leaching
Table - 89.5W x 89.5D x 75H CM
Chairs - 46W x 59.2D x 89H CM
Max. Weight Capacity: 110kg per Seat
Natural Oil Finish

SECTION 1 - CHAIRS
PARTS LIST
CAUTION!
This product weighs 17.9kg.
Assembly requires 2 people
to avoid injury.
A
Timber Components
B
x1
x1
CD
x1
S4 Allen Key
Hardware
x6 x1
x1

SECTION 1 - CHAIRS
ASSEMBLY INSTRUCTIONS
Step 1
Place Component A flat on the ground and insert
Component C and Component D into the relevant
slots.
Step 3
Once all the components are slotted together, ax
Component B to Component C and Component D
using 3 x S4 Screws and the Allen Key provided.
Step 2
Slot Component B onto the relevant inserts of
Component C and Component D.
Step 4
Carefully flip the chair keeping all components
together and repeat Step 3 on the other side.
A
CD
C
D
B
Allen
Key
SECTION 1 - CHAIRS
ASSEMBLY INSTRUCTIONS
Step 1
Place Component A flat on the ground and insert
Component C and Component D into the relevant
slots.
Step 3
Once all the components are slotted together, ax
Component B to Component C and Component D
using 3 x S4 Screws and the Allen Key provided.
Step 2
Slot Component B onto the relevant inserts of
Component C and Component D.
Step 4
Carefully flip the chair keeping all components
together and repeat Step 3 on the other side.
A
CD
C
D
B
Allen
Key
B
C
D
S4 x 3

SECTION 1 - CHAIRS
ASSEMBLY INSTRUCTIONS
Step 5
IMPORTANT SAFETY INFORMATION
Furniture should not be dragged at any time.
As an added precaution we strongly recommend you choose to tighten any loose fittings and joints after an initial
period of use of around 3-6 months. For assured long life of your furniture, regular checking and tightening of any
screws and bolts should be carried out on a 6-12 monthly basis.
Flip the chair to its upright position and tighten all screws.
Repeat for the remaining chairs.

SECTION 2 - TABLE
PARTS LIST
CAUTION!
This product weighs 21.4kg.
Assembly requires 2 people
to avoid injury.
A
Timber Components & Hardware
B
x4
x1
CM1
x1
Not Supplied
x8
Hammer or Mallet

SECTION 2 - TABLE
ASSEMBLY INSTRUCTIONS
Step 1
Place Component A flat on the ground (underneath
facing up) and insert 4 x Component B into the
relevant slotsand slot Component C onto the 4 x
Component B Inserts.
Step 3
Step 2
Using a hammer or mallet (not supplied) gently tap the
8 x M1 Metal Dowels into the available holes until the
have reached the other side of the opening.
IMPORTANT SAFETY INFORMATION
Furniture should not be dragged at any time.
As an added precaution we strongly recommend you check the
fixings and joints after an initial period of use of around 3-6 months.
For assured long life of your furniture, regular checking fixings should
be carried out on a 6-12 monthly basis.
Flip the table to its upright position
and check the 8 x M1 Metal Dowels
are firmly in place.
Hammer
or Mallet
B
B
B
B
C
A
M1 x 8