MINCOCO TP 21 User manual

Bidet TP21 Installation Guide
➢Precaution before installation:
Take out all the components from the package to avoid missing parts
The small washers and Teflon are very important to prevent leakage
Turn off the cold/hot water supply valve in case of leakage
Prevent scalding when installing hot water pipe
➢Components parts
2
8
6
5
4
1
2
3
7

1-Bidet 2- Hot Water PU Hose 3-Cold Water Metal Braided Hose 4-Hot Water T-adapter
5-Teflon 6-Hot Water Cap 7-Cold Water T-adapter 8-Installation Manual
➢Installation steps
Step 1: prepare tools
Step 2: Turn off the cold/hot water supply, flush the toilet to drain the tank
Setp3: take off the screws and remove the seat, then start to install the bidet
Step4: Install the cold/hot hoses to the bidet end
( Every connector has a washer in the hose to prevent leakage )

Setp5: take off the screw nut and install the metal T-adapter to supply cold water to bidet
(every joint should input washer and paste Teflon in case of leakage)
Step6: install the metal adapter and PU hose for the hot water
(every joint should input washer and paste Teflon in case of leakage)
Setp7: turn on cold/hot water switch
Setp7: Choose the right mode and adjust the water pressure and temperature properly

THANK YOU FOR CHOOSING MINCOCO