MityLite Reveal Installation guide

Laminate Tabletops:
MityLite Reveal, Elevare, and Madera linenless tabletops all feature a durable Wilsonart® laminate
surface. To ensure many years of reliable use, regular cleaning and care of your product is
important.
Daily Maintenance for Tabletops:
For daily cleaning of laminate surfaces, all you need is dishwashing liquid, warm water, and a
microfiber cloth. Apply a mixture of dish soap and water to the surface using your cloth. The cloth
should be damp, but not dripping wet. Rinse thoroughly with warm water and wipe dry.
Difficult stains, such as coffee or tea, can be removed using a mild household cleaner/detergent and
a soft bristled brush—repeat as necessary.
If a stain persists:
Use a paste of baking soda and water, then apply to the
affected area with a soft bristled brush (a toothbrush
works great). A light scrubbing of 10 to 20 strokes should
remove most stains. Although baking soda is a low abrasive,
excessive scrubbing or exerting too much force could
damage the decorative surface.
Cleaning & Care Instructions
Reveal, Elevare, & Madera Linenless Tables
Learn more at mitylite.com/resources
08.04.20

REVEAL, ELEVARE, & MADERA
CLEANING & CARE INSTRUCTIONS
Stubborn stains that resist any of the above cleaning methods may require the use of undiluted
household bleach or nail polish remover. Apply the bleach or nail polish remover to the stain and let
stand no longer than two minutes. Rinse thoroughly with warm water and wipe dry.
This step may be repeated if the stain appears to be
going away and the color of the laminate has not
been affected.
WARNING: Prolonged exposure of the laminate surface to
bleach will cause discoloration.
Hot pans and heat-producing appliances (such as
electric skillets), when set directly upon tabletops,
can mar the product’s beauty. Always use a heat
shield, hot pad, or trivet.
Recommended cleaning solutions to use on tabletops:
• Windex® • Formula 409®
• Glass Plus® • Purell Multi-Surface
• Fantastik® • Isopropyl Alcohol (Isopropanol)
• Mr. Clean®
Disinfecting Tabletops:
Alcohol and bleach are acceptable chemical disinfectants if used appropriately. As with any other
disinfectants, soiled surfaces need to be cleaned with water and detergent first. Bleach is a strong
and effective disinfectant—its active ingredient, sodium hypochlorite, is effective in killing bacteria,
fungi, and viruses.
Please note: If bleach is not properly used, it can be harmful to the user and cause long-term damage to
surfaces. Prolonged exposure of the laminate surface to bleach will cause discoloration.
Learn more at mitylite.com/resources
08.04.20

REVEAL, ELEVARE, & MADERA
CLEANING & CARE INSTRUCTIONS
Cleaners with the following active ingredients in various ratios and solutions pose a threat to any
surface and cause irreparable damage:
• Peroxide(s)
• Strong acids (phosphoric acid is often used, very low pH values)
• Strong bases (sodium hydroxide, potassium hydroxide, high pH values)
• Hydrochloric acid, sulfuric acid, or hydrofluoric acid
With all cleaners, exposure time is the key. Often surface damage is due to poor removal of the
cleaning agent (spills, drops, etc. that are not removed).
It is recommended to test any cleaner on a small area of the surface before using. Prolonged exposure of
disinfectants and sanitizers to laminate surfaces can cause degradation and/or discoloration.
Reveal Table Family Madera Table Family
Elevare Table Family
Learn more at mitylite.com/resources
08.04.20

REVEAL, ELEVARE, & MADERA
CLEANING & CARE INSTRUCTIONS
WARNINGS:
•Never use abrasive cleaners, steel wool, pumice stone, or scouring pads
• Never wax or sand, apply lacquer, or other topical finish
• Never expose tabletops to standing water
• Hair, textile, and food dyes can cause permanent stains (wipe up immediately with
dishwashing detergent or an all-purpose cleaner)
• Never place pots or dishes directly from the oven or burner on an unprotected laminate
surface as extreme heat can cause cracking or blistering
• Do not use oven cleaners on an unprotected countertop (wipe spills away promptly and
rinse several times with water)
• Rust removers contain harsh chemicals which will quickly cause permanent damage (Wipe
off all residue immediately, wash thoroughly with soapy water, and rinse several times)
• Steel wool and other abrasive pads will damage surfaces (don’t use for cleaning or store
steel on your countertop)
• Toilet bowl cleaners contain harsh chemicals that can cause permanent damage (wipe up
immediately, wash surface with soapy water, and rinse several times)
Powder-Coated Table Legs:
All MityLite table legs have a powder-
coated finish. To clean, use a soft cloth or
sponge and a mild detergent (pH5 to 8).
Avoid using a brush with tough bristles as
this might damage the surface. Then, wipe
down the surface with a soft cloth and
clean water.
Before using any cleaners, review the
cleaning ingredients or technical datasheets. Avoid using an abrasive cleaner or polish, and
cleaners that contain ketones, esters, and acetones (for example, nail polish remover).
Contact Wilsonart Technical Services at 1.800.433.3222 with questions.
Learn more at mitylite.com/resources
08.04.20