MIW TANK-3076 User manual

3 SPEED OSCILLATING WALL FAN
MODEL: TANK-3076
READ AND SAVE THESE INSTRUCTIONS
Watts (W) Amps (A)
Volts
Low Low
191
174
1.83
0.82
Medium Medium
217
196
2.24
0.93
High High
276
241
3.46
1.35
230V / 50Hz
110V / 50Hz
SPECIFICATION
1 - Screw
2 - Handle
3 - Screw
4 - Foot
5 - Screw
6 - Wheel
7- Screw
UNPACKING, ASSEMBLY, HANDLING AND POSITIONING
1. Where applicable remove the packing taking great care in not damage the appliance.
2. Use protective gear (gloves) for the positioning and assembly.
surface.
a. Fix the handle (No.2) on the fan by tighten screw (No.1)
b. Fix the foot (No.4) on the fan by tighten screw (No.3).
c. Fix the wheel (No.6) on the fan by tighten screw (No.7) and nut (No.5).

ASSEMBLY AND OPERATING INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
CAUTION:
Read and follow all intructions before operating fan. Do not use fan if any parts
are damaged or missing.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE TO WATER
OR RAIN.
TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT USE THIS FAN
WITH ANY SOLID STATE SPEED CONTROL DEVICE.
RULES FOR SAFE OPERATION :
1. Never insert fingers or any other objects through the grill guard when fan is in
operation.
2. Unplug power cord when moving from one location to another.
3. Unplug power cord when removing grill for cleaning.
4. Be sure fan is on a stable, flat surface when in operation.
5. Do not use fan in windows. Rain and moisture may create electrical hazard.
CAUTION: Do not alter the fan's assembly in any way.
WARNING:
BE SURE FRONT AND REAR GRILL SCREWS ARE TIGHTENED BEFORE OPERATING.
CAUTION:
The knob must be fully tightened before assembling the FAN HEAD TO THE
INNER TUBE.
Do not alter the blade’s angle, securely tighten the blade securing screw.
COLUMN/MOTOR ASSEMBLY INSTRUCTIONS:
Insert the motor at top hole of the inner Tube.
Then firmly tighten the screw at the two holes or the fan neck.
TOOLS REQUIRED Wrench
OPERATING INSTRUCTIONS
TO ADJUST AIRFLOW UPWARD OR DOWNWARD:
Tilt fan head to the desired angle.
Loosen THE POSITION SCREW first and then loosen the knob. Tilt fan head to the
desired angle then firmly tighten THE POSITION SCREW first and then tighten the
knob.
TO MAKE THE FAN OSCILLATE:
Press down the knob at the top of the fan head.
TO STOP THE FAN OSCILLATE:
Pull up the knob at the fan head.
SPEED CONTROL:
Rotate THE SWITCH to 0, 1, 2 and 3 designates OFF, LOW, MEDIUM, and HIGH
speeds respectively.
WARNING:
Unplug from electrical supply source before cleaning:
Use soft damp cloth to clean. Then wipe with dry cloth.
Do not use cleaning solution that is harmful to paints or plastics.
Do not bend the blades.
The motor bearings are permanently sealed and do not require additional
lubrication.