ML Accessories Knightsbridge IN0025 Instruction Manual

IP65 ROTARY ISOLATOR
ML Accessories Limited
LU5 5TA
www.mlaccessories.co.uk V1-0614 – PS
93
IP
65
INSTALLATION & MAINTENANCE MANUAL
IN0025. IN0026. IN0027.

These instructions should be read carefully and retained after installation for further
reference and maintenance.
GENERAL INSTRUCTIONS
LOCK OFF FACILITY
GENERAL
WARRANTY
SAFETY
INSTALLATION
• Installation of this product should only be carried out by a qualified electrician or
competent person to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this product is fitted) does not exceed
the rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this product when deciding the
location for installation
• This product is Class I and requires an earth
• This product is IP65 rated
• Ensure the switch is in the OFF position
• Unscrew the cover screws and remove the cover
• Choose a suitable flat fixing surface that will support the weight of the switch. On the
back of each switch is detailed the fixing centers for the fixing holes. Mark, drill and plug
the wall for the fixings and fix the switch to the wall
• Using the cable entry knockouts provided, remove the appropriate knockouts and install
the mains cables into the switch ensuring that the correct IP rated gland is used to
maintain the IP rating of the switch
• For ease of wiring the switch can be removed from the base and clicked back in once
wiring is complete (see diagram on the next page)
• Wire the switch in accordance with the machine/appliance manufacturer’s
recommendations
• After the wiring to the switch has been completed, ensure that the control/switch
knob is still in the off position, and replace the cover and outer-casing screws. Do not
overtighten the cover screws
• Test for correct operation
The switch has the provision to have 3 separate padlocks inserted in the OFF position only.
The unit should be recycled in the correct manner when it reaches the end of its life.
Check local authorities for where facilities exist. Clean with a soft dry cloth only, do not
use aggressive cleaning products or solvents which may damage the product.
This product has a warranty of 1 year from date of purchase. Failure to install this product
in accordance with the current edition of the IEE Wiring Regulations, improper use, or
removal of the batch codes will invalidate the warranty. If this product should fail within
its warranty period it should be returned to the place of purchase for a free of charge
replacement. ML Accessories does not accept responsibility for any installation costs
associated with the replacement product. Your statutory rights are not affected. ML
Accessories reserve the right to alter product specification without prior notice.
Cover screw
Knob
* Detail B
Mounting
Screwdriver Cover
Switch assembly
Enclosure base
Rail slide
Switch
Use screwdriver to pull rail - slide to
remove switch from enclosure base