gofanco mDPMST2DP User manual

Mini DisplayPort MST Hub
to 2x DisplayPort
User's Guide
G4-0042A
P/N: mDPMST2DP

2
Thank you for purchasing from gofanco. Our
products aim to meet all your connectivity needs
wherever you go. For optimum performance
and safety, please read the instructions carefully
and keep this User’s Guide for future reference.
If you need more information about our
products, please visit www.gofanco.com. For
technical support, please email us at
[email protected]. For drivers/manuals
download, please go to www.gofanco.com/
download.
Important Safety Notices
Please read safety instructions carefully before
installation and operation.
• Please pay close attention to all warnings
and hints for this device
• Do not expose this unit to rain, heavy
moisture, or liquid
• Do not repair the device or open the
enclosure without professional guidance
to avoid electric shocks. Doing so may void
your warranty
• Keep the product in a well-ventilated
location to avoid damage from overheating

3
Introduction
gofanco Mini DisplayPort MST Hub to 2x
DisplayPort (part# mDPMST2DP) enables you
to connect with 2 external monitors to your Mini
DisplayPort enabled computer for multitasking.
Specifications
PackageContents
•Mini DisplayPort MST Hub to 2x
DisplayPort
•Micro-USB Power Cable
•User's Guide
System Requirements
•PC with an available DisplayPort (DP 1.2
recommended)
•Windows®10 / 8.1 & 8 / 7 (32-/64-bit)
Output Signal DisplayPort
Ports 2
Compliance DP 1.2
Connectors Input: 1x Mini DisplayPort, Male
Output: 2x DisplayPort, Female
Resolution Up to 3840x2160@30Hz
Audio 7.1-CH

4
Product Layout
Figure 1: Layout
•Mini DisplayPort Input: Connect to PC's
Mini DisplayPort
•DP Output (x2): Connect to DisplayPort
displays with DP cables (not included)
Or connect to DP adapters (not included) to
HDMI, DVI or VGA to use with HDMI/
DVI/VGA displays
•Power Jack (Micro-USB): Connect to PC's
USB port for power with the included
Micro-USB power cable. *Note: This
connectionisrequiredtopower thisadapter.
Power Jack
(Micro-USB)
Mini DisplayPort Input
DP Output (x2)

5
Hardware Installation
Important:If the sourceMiniDisplayPortoutput
doesn't support DP 1.2, the Multi-Stream
Transport (MST) function will be disabled and
thishubbecomesa Splitter, mirroring your video
source across all displays.
1. Power off all devices you plan to connect to
the unit.
2. Connect the unit to your PC's Mini
DisplayPort connector.
3. Connect your DisplayPort monitors to the
unit's DP Outputs with DisplayPort cables
(not included).
4. Connect the unit's Power Jack to PC's USB
port for power source with the included
Micro-USB power cable.
5. Power on all of the connected devices.
6. It is ready for use.

6
Blank Page

7
Disclaimer
The product name and brand name may be
registered trademarks of related manufacturers.
TM and ® may be omitted on the user’s guide.
The pictures on the user’s guide are just for
reference, and there may be some slight
differences with the actual products.
We reserve the right to make changes without
prior notice to a product or system described
herein to improve reliability, function, or design.

Thank you for choosing gofanco
www.gofanco.com