
Assembling Manual
01. Package Content : 1 commode frame, 1 backrest,
1 seat with lid & 1 bucket with lid.
02.
Place commode on the ground and swing legs forward.
03.
Swing the bucket holder platform up and insert push
buttons on each side into the brackets located on each
leg. (Be sure push buttons are fully engaged into place
on both sides and check by pulling outward on the legs)
04. Insert the backrest into the brackets located on the
rear legs. (Be sure push button is fully engaged on both
sides and check by pulling upward)
05. Place bucket into the bucket platform holder.
06. Place the toilet seat onto the frame so that plastic
clamps rest on the rear cross frame and on each side of
the bucket holder platform. Push down forcefully until
brackets are fully attached to the rear cross frame.
07.
Be sure toilet seat is in the down position before
trying to attach the lid. Place the lid onto the frame so
that plastic clamps rest on the rear cross frame and on
each side of the toilet seat brackets. Push down forcefully
until brackets are fully attached to the rear cross frame.
Warranty
Your Mobilita branded product is warrantied to be free
of defects in materials and workmanship for the product
of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Warranty is an
expression of our confidence in the materials and
workmanship of our products and our assurance to the
consumer of years of dependable service.
This warranty does not cover device failure due to owner
misuse or negligence, or normal wear and tear. The
warranty does not extend to non-durable components,
such as rubber accessories, casters, and grips, which are
subject to normal wear and need periodic replacement.
If you have a question about your Mobilita device or this
warranty, please contact an authorized Mobilita dealer.
© 2017 Eternity Distribution Pvt. Ltd. All rights reserved
Mobilita is a trademark of
Eternity Distribution Pvt. Ltd.
Chennai, Tamil Nadu, India | Made in China for Mobilita
08. Adjust the height of the legs by locating the
push-button on each leg and sliding the leg up or down
to the desired height. Make sure all legs are fully
engaged and adjusted to equal heights.
Part# M300 - P1
Part# M300 - P3 Part# M300 - P4
Part# M300 - P2