Modena KS Series Owner's manual

User
Manual Book
Kitchen Sink
Series
KS

TABLE OF CONTENTS
INSTALLATION 3
Top-mount Sink 3
Undermount Sink 4
This guide book explains everything you need to know about your new
product. Please contact our Customer Care should you need further
assistance through www.modena.com.

3
Top-mount Sink
1. Place the sink upside down
in the position where it will
be installed and draw line
around the outline of the sink
on the countertop with a
pencil.
2. Draw another line 10 mm
inside the first one. Cut a hole
in the countertop following
the second line. (Another
option is use the dimension
provided on the label
attached on the product).
3. Adhere sealing tape around
the underside of the edge of
the sink, be careful to lay it
smoothly (without ridges).
4. Place the anchor braces
vertically and pull the up to
lock into their horizontal
position.
INSTALLATION

4
5. These anchor braces are
designed for use with
countertop 30 - 40 mm thick
(1). If the countertop is thinner,
insert wooden wedges
between the countertop and
the braces to secure them (2).
After placing two at each
corner, place the rest evenly
spaced around the perimeter
of the sink.
6. Tighten the screws of the
anchor braces to secure the
sink in place.
Undermount Sink
1. Place cut out template on desired
sink location. Draw lines around
the outline of the template.
2. Cut along the line using appropriate
cutting tool.
NOTE:
Make sure that the line dimension corresponds to the bowl
dimension before cutting.

5
3. Drill the underside of the countertop
as shown in the diagram below.
4. Insert screw anchors into the drilled
holes.
5. Place fixing brackets over the screw
anchors. Insert the screw provided,
but don’t fully tighten.
6. Check alignment between the bowl
and the cut out hole.

6
7. Apply suitable wet area sealant
recommended for stainless steel
sink and countertop material.
8. Tighten the screws carefully and
remove the excessive sealant.

06/21