Modern Classic KROSSWOOD User manual

Assembly Instructions
Base/Vanity with 3 Drawers
Wood
Dowel
Cam-Lock
Screw
Cam-Lock
Nut ¾” Screw Bumpers
Back Panel
1 2
3 4
Tools needed but not provided:
Rubber Mallet
Wood Glue
½” Screw
*Do not put glue directly
on the dowel *Place 2-3
drops of glue in the hole
before inserting each
dowel
Insert dowels
after glue drops
Back Panel
Drawer Front
X 3
Drawer Back
X 3
Drawer Side
X 6
Front Cross
Brace X 3 Back Cross
Brace
4 ½” Toe Kick
Phillips
Screwdriver
Drawer Slides
X 6
Right Panel
*Place 2-3 drops of glue in side
panel holes before attaching Cross
Braces, Toe Kick, Cabinet Bottom
and Back Panel
Left Panel
Backset 1/8”
Cabinet
Bottom
Left
Panel
Right
Panel
*Push all the way in
until less than 3/8” of
dowel is exposed
Left Panel
Right Panel
Cabinet Bottom
Drawer Bottom
X 3
4-1/2” Toe Kick
Front Cross Brace
Front Cross Brace
Back Cross Brace
Cabinet
Bottom
C A B I N E T S
B y M o d e r n C l a s s i c
X 16
*Screw in Cam-Lock Screw until
threads are no longer visible for
both Right and Left Panels
X 12
*Set and screw in 6 Drawer Slides
for both Right and Left Panels

Hook in back of drawer 1st Set Pin in Predrilled
hole
5 6
8 9
7
Slide Drawer Bottom
in Groves
Back Outside View
Back Inside View
Place a drop of glue in each space
X 16
Tighten all
Cams
X 2
*Repeat steps 7 & 8 for all 3 drawers
*Repeat steps 7 & 8 for all 3 drawers
Drawer Bottom
(Underside View)
Place 1 Rubber Bumper on
each side of each drawer
X 6

Twist wheel for drawer alignment
10 11
13
14
Drawer Bottom
(Underside View)
Hinge Adjustment as Needed For Door Alignment
(In/Out)
Side-Side Up-Down Front-Back
* Drawer shown from underneath installed on slides
Drawer Adjustment
Insert all three drawers