Moducase DF120 User manual

DF version modular display case
Model: DF120

Back frame – No magnet
Front frame – With magnet

1. Back frame
*Note Extrusion with a
loose screw is top side

Slide loose screw to centre position
**Take note of frame orientation. Back frame’s extrusion with loose screw should be facing up

Screw centre top support onto back frame

2. Top panel (Inner side facing down)
*Tear off protection films
3. Side Panel
4.
Screw holes face
front
Flip unit, rest on the back. Tear off
protection film

5. Slide in front frame
Top direction, with nut
Top direction
Slide loose screw to the centre
Top direction, with nut
Top direction
Slide loose screw to the centre
Top panel
Top panel

6. Secure front frame
Enhanced display weight loading. If enhanced is not included in your display, please skip to
step 8.
7. Enhancement installation
a. Insert and align sliding nut on front and back bottom frame to position and
screw aluminium bar in
Nut 18x
Angle bracket 4x

Front
Back
Align according to the “This position”
label
Insert at an angle and push in

b. Insert angle bracket and screw it at 4 corner
Insert 4x sliding nut at an angle and
push in
Secure angle bracket with M5
black bolts
Back
Front
Proceed to step 9

8. Align centre support bar
Align according to the “This position”
label
Insert at an angle and push in

9. Insert 16x sliding nut
Insert at an angle and push in

10. Push sliding nut on back frame to position, according to the back panel’s hole. Screw
on back panel with 16x M5 screw. ( backdrop panel’s Inner side facing display)
11. Flip display to rest on the back
*Take note of the orientation of the display case
Top orientation,
with nut

12. Insert L-bracket and screw it to frame
Top
orientation,
with nut

13. Flip unit to rest on the bottom frame
Front
Back
Top orientation,
with nut

14. Insert bottom panel
15. Insert Front cover

16. Insert top panel rubber
Flip the display to rest on the ba
Front
Rubber slot
(Shaded grey)

17. Screw in front safety hand screw