Molpir FMS5723 User manual

INSTALLATION MANUAL FOR 7“DIGITAL
MONITOR WITH 60° TIPPING HOLDER
1.
2. Tools re uired for installation:
S
crewdriv
er
PH2
Screwdriver
PH0
Monitor
holder
with
60°
tipp
ing
Plastic monitor frame
Screws:
8 ks M5 10mm
2 ks M2 6mm
Monitor cable
FMS5723
FMS5723
-
HH
-
60
D
ate
07/06/2010
Side
1 / 4
NM_FMS5723_001_07062010_EN
FMS
5723

3. Installation description
Step 1: Put the metal holder into the seat and fi it with 3 screws
(M5 10 mm) through the holes marked with the red
circle
Step 2: Installation of the monitor cable:
1) Connect POE cable (FMS-CA04-........) to the monitor
2) Put the cable into the chase
3) Fi the cable in the chase with the adhesive tape
Picture
1
–
F
i ing
of hinge
on the seat with screws
Picture 2 – Monitor cabling
m
onitor
a
cabling
Date 07/06/2010 Side 2 / 4
NM_FMS5723_001_07062010_EN

Step 3: Install the monitor on the holder
1) Hang up the monitor on the T-slot of the holder (hinge)
2) Fi the monitor with 2 screws (M2 6mm)
Step 4: Connect cables AUX-IN and SPK-OUT if is it necessary
Picture
3
–
S
uspension
of the monitor
on the hinge
Picture
4
–
Fi ing of monitor
on the
hinge
Picture 5 – Cables AUX-IN and SPK-OUT
connection
Insulate the joint with
insulating tape
M2 6 mm
Date 07/06/2010 Side 3 / 4
TI_FMS5723_001_07062010_EN

Step 5: Installation of the monitor plastic frame
1) Tip up the monitor to 45° ~ 60° angle
2) Put the plastic frame on the holder with the monitor on
Step 6: Fi the plastic frame with 5 screws (M5 10mm)
Picture
6
–
Installation of the holder
Picture
7
–
Fi ing of h
older
with screw
s
M5 10 mm
Date 07/06/2010 Side 4 / 4
TI_FMS5723_001_07062010_EN