Monessen Hearth HO24-R User manual

Monessen • Highland Oak Installation Instructions • 4604-908 Rev. A • 05/18
Log Placement Instructions
Models: HO18-R, HO24-R, HO30-R
WARNING!
The positioning of the logs is critical to the safe, clean operation of this gas log set. Sooting and other problems may
result if the logs are not properly positioned per these instructions. Failure to position in accordance with the diagrams
below, or failure to use only parts specically approved for this log set may result in property damage or personal injury.
Item Description Qty. HO18-R HO24-R HO30-R
1. Ember Chunk 1 81D0110 81D0110 81D0110
2. Right Front Log 1 81D0011 81D0019 81D0027
3. Right Rear Log 1 81D0012 81D0020 81D0028
4. Left Rear Log 1 81D0013 81D0021 81D0029
5. Left Front Log 1 81D0014 81D0022 81D0030
6. Left Top Log 1 81D0015 81D0023 81D0023
7. Right Top Log 1 81D0016 81D0024 81D0024
8. Right Front Log 1 81D0017 81D0025 81D0025
2
3
4
5
6
7
8
1
(BENEATH #7)

2Monessen • Highland Oak Installation Instructions • 4604-908 Rev. A • 05/18
NOTE: Installation instructions are the same for 18”,
24”, and 30” log sets. Pictures used in this manual
illustrate the 24” set. Some variation may exist between
the images and the set.
INSTALL 18", 24" AND 30" (F,R) HIGHLAND
OAK LOGS ON NATURAL BLAZE BURNER
1. Place the #1 log (the “chunk”) on the grate bar right side
of the burner adjacent to the controls. Figure 1
Figure 2
LG621
place log 2
Right Front Log #2
2. Place front right log (#2) on right pin located on burner
and right grate bar. Figure 2. After placing front right log,
ensure log is fully upright and tilting towards the back
of the burner.
Figure 1
LG620
place log 1
Ember Chunk
Log #1
Figure 4
LG623
place log 4
Left Rear Log #4
Figure 3
LG622
place log 3
Right Rear Log #3
3. Place right rear log (#3) on pin located on rear support
bracket and rest left side of log on front right log. Figure
3. After placing right rear log, ensure log is fully upright
and does not tilt forward. Slide #1 log ember chunk back
to contact right rear log.
4. Place left rear log (#4) on pin located on rear support
bracket on left side and left grate bar. Figure 4
5. Place left front log (#5) on left pin located on burner and
left grate bar. Rest top right portion of log on right front
log. Figure 5
Figure 5
LG624
place log 5
Left Front Log #5

Monessen • Highland Oak Installation Instructions • 4604-908 Rev. A • 05/18
Monessen, a brand of Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 50044
www.monessenhearth.com
LG626
place log 7
Left Top Log #6 Right Top Log #7
6. Place top left log (#6) on left rear log (#4) and left front
log (#5) using locating grooves on bottom of #6 and
locating blocks on logs #4 and #5. Figure 6
7. Place right top log (#7) on right rear log (#3) and right
front log (#2) using locators on the bottom of log #7 and
locators on logs #2 and #3. Figure 6
8. Place small right front top log (#8) on log #7 and log
#2 using locating grooves on the bottom of log #8 and
locating blocks on log #7 and log #2. Figure 7
Figure 6
Figure 7
LG627
place log 8
Right Front
Top Log #8
PLACE THE DECORATIVE ROCK
Optional volanic rock may be placed around the unit on
the oor of the rebox. Be sure to avoid any areas on the
burner itself.
CAUTION
DO NOT sprinkle volcanic rock on the logs,
around the pilot, or on or near burners. This
may cause sooting. Place volcanic rock only
on the oor of the replace.
During initial operation of the new heater,
new burning logs and/or rock wool will give
off a paper burning smell and orange ames
will be present. Simply open the windows for
a few hours to vent the odor.