Money Controls Condor Plus User manual

Condor Plus Toolkit TSP081.doc Issue 1.1 – June 2004
This document is the copyright of Money Controls Ltd and may not be reproduced in part or in total by any means,
electronic or otherwise, without the written permission of Money Controls Ltd. Money Controls Ltd does not accept
liability for any errors or omissions contained within this document. Money Controls Ltd shall not incur any
penalties arising out of the adherence to, interpretation of, or reliance on, this standard. Money Controls Ltd will
provide full support for this product when used as described within this document. Use in applications not covered
or outside the scope of this document may not be supported. Money Controls Ltd. reserves the right to amend,
improve or change the product referred to within this document or the document itself at any time.
©Money Controls 2004. All rights reserved.

Condor Plus Toolkit TSP081 Issue 1.1 – June 2004
©Money Controls 2004. All rights reserved.
Page 2 of 7
Contents
1. Diary of Changes........................................................................................................................................... 3
2. Introduction.................................................................................................................................................... 4
3. Condor Plus Connectors .............................................................................................................................. 5
4. Coin Enable.................................................................................................................................................... 6
5. Coin Teach..................................................................................................................................................... 6
Tables
Table 1: Connector Descriptions ............................................................................................................................. 5
Figures
Figure 1: Toolkit Connections.................................................................................................................................. 4
Figure 2: Connector Positions ................................................................................................................................. 5
Figure 3: ccTalk Interface - Connector 3................................................................................................................. 5
Figure 4: Rotary Switch v Coin Windows................................................................................................................. 6

Condor Plus Toolkit TSP081 Issue 1.1 – June 2004
©Money Controls 2004. All rights reserved.
Page 3 of 7
1. Diary of Changes
Issue 1.0………………………………………………………………………………...21st August 2003
Issue 1.1………………………………………………...…………………………………30th June 2004

Condor Plus Toolkit TSP081 Issue 1.1 – June 2004
©Money Controls 2004. All rights reserved.
Page 4 of 7
2. Introduction
The Toolkit is designed to interface to the Condor Plus coin acceptor and enable the following
features:-
¾The ccTalk interface is the single connection between the Condor Plus and
the toolkit. Power should be applied to the mech after the connection to the
toolkit has been made.
¾There are two programming functions; Coin Enable and Coin Teach.
Figure 1: Toolkit Connections

Condor Plus Toolkit TSP081 Issue 1.1 – June 2004
©Money Controls 2004. All rights reserved.
Page 5 of 7
3. Condor Plus Connectors
Figure 2: Connector Positions
Table 1: Connector Descriptions
Conn1 Parallel Interface
Conn2 Divertor Driver
Conn3 ccTalk Interface
Conn3 is the ccTalk connector which the Toolkit will connect to.
Figure 3: ccTalk Interface - Connector 3

Condor Plus Toolkit TSP081 Issue 1.1 – June 2004
©Money Controls 2004. All rights reserved.
Page 6 of 7
4. Coin Enable
1. To specify the coin to be enabled, turn the Condor Plus rotary switch to the position of the
specific coin to be enabled. (see Figure 4).
Figure 4: Rotary Switch v Coin Windows
2. Press the push button (see Figure 1) on the Toolkit.
3. All coins are inhibited and then the selected coin is enabled.
4. The Condor Plus LED will momentarily flash RED, then return GREEN to indicate
successful coin enabling. The rotary switch should then be returned to ‘0’, power switched
off, and the Toolkit disconnected.
5. Coin Teach
1. Turn the Condor Plus (CP) rotary switch to position F.
2. Depress the push button on the Toolkit.
3. The LED will turn RED. The CP is now ready for teaching. Insert a minimum of 8 individual
coins or tokens. The CP LED will flash GREEN when sufficient number of coins have been
inserted.
4. The rotary switch should then be returned to ‘0’, powered off and the Toolkit disconnected.
The coin/token has been taught AND Window 7 has been enabled.

Condor Plus Toolkit TSP081 Issue 1.1 – June 2004
©Money Controls 2004. All rights reserved.
Page 7 of 7
This manual is intended only to assist the reader in the use of this product and
therefore Money Controls shall not be liable for any loss or damage whatsoever
arising form the use of any information or particulars in, or any incorrect use of the
product. Money Controls reserve the right to change product specifications on any
item without prior notice.