MOOV CUBE CHAIR User manual

IMPORTANT SAFETY INFORMATION
•Our furniture is made for children, and recommended usage is up to 50kgs.
•Suitable for indoor and outdoor use, equipment should be kept dry and protected from the
elements.
•These pieces are not made for climbing or balancing on. Adult supervision is recommended.
•Check equipment before each use. Tighten any screws required.
•Our warranty excludes natural wear and tear, improper use or incorrect assembly.
•The furniture should only be moved by an adult.
INSTRUCTION MANUAL
CUBE CHAIR & BENCH

INSTRUCTION MANUAL FOR CUBE CHAIR & BENCH
What you need: What’s included:
Important notes before you start
Steps
•Place on flat even ground while constructing the equipment
•Ensure pieces are aligned with the pre-drilled holes and screwed in level. Hold the pieces up and in
place while you screw them in. If they are not aligned construction will be difficult and may cause
damage to the screws. If its hard, stop realign and try again. If you choose to use a drill, please do so at
your own discretion, if used incorrectly you may damage the screws. We recommend a low speed
setting.
•Do not fully tighten until instructed. Beware of overtightening. This can cause distortion of the frame.
•As helpful as our little people can be do not construct the equipment with them present. Small parts
and sharp edges pose a risk.
•Keep small parts out of reach of children.
•20 minutes
•Two pairs of hands
•8 x 60mm brass screws
•1 x Allen Key
•2 x side pieces (branded)
•1 x backrest
•1 x seat
Place the seat sides at the same level
(there are two heights. Ensure the
recessed edges face in.
A
BAttach the seat to the first edge, do
not fully tighten. Then attach the
second side, again do not fully
tighten.
CAttach the backrest and fully
tighten all screws.
Question? Email us at [e-mail]