76
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
CLEANING AND MAINTENANCE
1. Always switch off and unplug your appliance from the power supply and allow it to
completely cool before cleaning and maintenance.
2. Do not immerse the appliance into water or any other liquids to avoid damaging it.
3. To maintain optimal performance, it is recommended to descale the appliance
periodically. Use only toxic free descaler such as citric acid. Add citric acid into water
proportionately. Boil and reboil water three (3) times to completely remove the
limescale. Discard any remaining water during descaling.
4. Do not use any chemical, metal, wood or abrasive cleansing agents to clean the
appliance housing. Always use a damp cloth.
5. Always handle the appliance with care. Avoid placing it near the edge of the table and
counter tops to protect against deforming or damaging the appliance in case it
accidentally topples over.
STORAGE
If the appliance is not going to be used for a long duration, clean and unplug it from the
power supply and place it back into its original packing box to prevent humidification or
damage to the electrical components.
Environment friendly disposal
DISPOSING WATER FROM THE DISPENSER
DRIP TRAY
To dispose water when the dispenser drip tray is full,
use one hand to firmly grasp and stabilize the
appliance by one hand and another hand to lift up
the dispenser drip tray slightly to remove it. Proceed
to empty water inside the dispenser drip tray insert it
into its proper place.
BEFORE FIRST USE
Clean your Instant Boil Hot Water Dispenser thoroughly before using it for the first time.
Fill it with clean water and boil. Discard boiled water, allow to cool before filling with clean
water and boiling again. Always unplug from the power plug from the power supply and
allow to cool down before cleaning or maintenance. Wipe the Hot Water Dispenser’s
surface exterior only with a damp cloth and dry with a soft dry cloth.
1. Open the lid, fill the water tank with the desired amount of water, and then close the lid.
IMPORTANT: Water level must be within the “MIN” and “MAX” level.
BOILING WATER
1. Connect power plug to the power supply and fill in water with desired quantity of water,
ensuring that water level is above the “MIN” level but below the “MAX” level. Place your
cup on the removable dispenser drip tray, aligning with the water spout.
2. When turn on the power switch at the base of the
operation indicator light will illuminate.
3. The heating element begins to work, and boiling will
begin in about 5 seconds.
4. Boiled water will flow out continuously from the
water spout (First flow about 8 seconds, and 3-5
seconds afterwards).
5. Turn the function knob to OFF position after boiling
has completed, and the indicators lights will also
turn off. To reboil water again turn on the function
knob to repeat the same procedure.
WARNING!
1. Exercise extreme caution! Boiled water and steam
is extremely hot!
2. When there’s insufficient water inside the appliance, the water protection indicator light
will illuminate as a reminder to replenish water.
3. This appliance features a manual thermostat cut-off to protect it in the event of
overheating or a malfunction. You can reset the thermostat by using a reset key easily.