
7
OPERATING INSTRUCTIONS
NOTE:
• The appliance features a manual thermostat to
recover the heating function during
abnormal operation.
• If there is no power supply to the appliance, the
appliance has stopped operating, or water is not
boiling, the thermostat can be reset by inserting the
reset key into the reset button hole located at the back
of the appliance.
CARE & CLEANING
• Always switch off, disconnect the appliance from the power supply and allow it to cool
completely before cleaning.
• Do not immerse the appliance into any liquids to avoid damaging the appliance.
• To ensure optimal performance, it is recommended to descale the appliance when the
“Descaling” symbol is flashed on the control panel display.
• Use only toxic free detergent such as citric acid or vinegar.
• Add some citric acid or vinegar into the water tank and fill water until the " ax" level.
• Operate under 100 C setting at volume 000 for 2 - 3 times to eliminate any limescale.
• After completion, discard the boiled water and add clean water to boil before drinking.
• Do not use any chemical, metal, wood or abrasive detergent to clean the appliance
housing. Use a damp cloth only.
• Always handle the appliance gently, do not place it near the edge of the table and
countertops to protect against deformation or damage
in the event of it toppling over.
REMARKS
• After cleaning the appliance, open the drainage
stopper to discard any water remnants.
Note: Tighten the d ainage stoppe afte opening it.
DISPOSAL OF WATER WHEN WATER TRAY IS FULL
• Grasp the appliance with one hand, and another hand to slightly
lift up to detach the water tray. Empty the water tray and insert
it into its original position.
STORAGE
• If the appliance is not to be used for a long duration, unplug and
clean it, and then store it into its packing box to avoid damaging
or humidifying the electrical components.
6
BEFORE FIRST USE
• Clean the water tank before first use.
• Disconnect power plug from the power supply.
• Fill water tank with clean water and discharge before refilling with clean water once more
for normal operation.
FILLING WATER
1. Open the water tank lid, fill the water tank with the desired amount of water, and then
close the lid. Note: the water level must be less the " ax" level. You can select two
methods as per the following:
2. OBTAIN DESIRED WATER
• Connect power plug into the power supply and fill the desired amount of water.
• Place a cup on the removable water tray, ensuring it aligns with the spout.
• Select the desired temperature and volume and press the ON/OFF button to operate the
appliance.
• The water spout will dispense water continuously in about 5-10 seconds.
• Press the ON/OFF button stop / begin dispensation.
REMARKS
• Do not touch the boiled water and steam in order to protect against scalding by boiled
water and hot steam.
• Safety cut-out: If the appliance stops operating with a beep sound and the PCB panel
shows the E7 symbol, this means there is insufficient water inside the water tank. Please
fill the water tank below the " ax" level.
• The appliance can memorize the last operation method until the plug is disconnected.
• As the appliance has memory function when powered on, it is recommended to use about
the first 60 seconds to obtain the desired water temperature. When switched off the
memory will reset.
• As ambient temperature fluctuates every day, the water volume will undulate within -15%
to +15%.
OPERATING INSTRUCTIONS