CARE AND CLEANING
7
BEFORE FIRST USE
If you are using the kettle for the first time, it is recommended to clean it before use
by boiling the Max capacity of water once and then discard the water. Wipe the
surface with damp cloth.
1. To fill water into the kettle, remove it from the power base and open the lid by lifting the
lid handle. Always fill the kettle between the minimum (0.5L) and maximum (1.7L.)
marks. Too little water will result in the kettle switching off before the water has boiled.
NOTE: Do not fill water over the maximum level, as water may spill out of the
spout when boiling.
2. Close the lid. Position the kettle on the power base. Ensure the appliance contacts with
the power base completely.
3. Insert power plug into a power supply. Press down the power switch to “I” position and
the switch light will illuminate.
4. Water will begin boiling. nce water has boiled, the kettle will power off automatically and
the switch light will extinguish. You can shut off the power by pressing the switch at any
moment during boiling water.
NOTE:Ensure that the power switch is clear of obstructions and the lid is firmly
closed. The kettle will not power off if the switch is obstructed or if the lid is left
open.
5. Lift the kettle from the power base and then pour the water.
WA NING: Exercise caution when pouring water from the kettle. Boiling water
and escaping hot steam from an open lid may scald!
The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20
seconds before reopening to boil water. The kettle may be stored on the power
base when not in use.
NOTE: Ensure power supply is turned off when kettle is not in use.
BOIL-DRY PROTECTION
The boil-dry protection will automatically activate and power off the kettle if it is accidentally
operated without water. Should this occur, allow the kettle to cool before filling with cold
water and re-boiling.
1. Always disconnect the appliance from the power outlet and leave it to cool down
completely before cleaning.
2. Never immerse the appliance or power cord in water and other liquids, or allow moisture
to contact with these parts.
3. Clean the external housing by wiping with a damp cloth and mild detergent cleanser.
4. CAUTION: Do not use harsh chemicals, steel, wooden or abrasive cleaners to clean the
appliance’s exterior.
5. Clean the filter with a mild detergent and damp cloth at intervals.
REMOVAL OF MINERAL DEPOSITS
Mineral deposits in tap water may cause the appliance interior to discolour. To
remove this build-up, use non-toxic Liquid Descaler.
ALTE NATIVELY:
• Fill the kettle with 3 cups of white vinegar to water and allow to stand overnight. Do not
boil.
• Empty the solution from the appliance. Any remaining stains inside the spout can be
removed by rubbing with a damp cloth.
• Fill the appliance with clean water, bring to boil and then discard the water. Repeat and
the kettle will then be ready for use.
STORAGE
When not in use or for storage, wind the power cord around the cord storage under the base
of kettle. Cover and store the appliance in a cool place.
ENVIRONMENT-FRIENDLY DISPOSAL
You can help protect the environment!
Please remember to respect the local regulations and dispose non-operating
electrical equipment to an designated waste disposal centre.
6
OPERATION INSTRUCTIONS
