Irregular Flame Burner head not placed in proper Place burner head in proper
position position
Short Flame Not enough gas pressure Inspect the gas cylinder and
the regulator
Easy to blow out Excessive air supply Adjust the damper
Abnormal Long and yellow Insufficient air supply Adjust the damper
Flame flame (or with
black smoke)
Asymmetric flame Burner head hole clogged Clean the holes on burner
head
Gas Leakage Brittle pipes breaks off easily Replace gas pipe
(or peculiar smell)
Unable to light up flame After the gas disperse then try
again
FAILURE FAILURE REASON SOLUTION
Burners do not light Gas source not switched on Turn on the source switch
The gas pipe is leaking Replace gas pipe
Out of gas supply Replace gas source
Mis-positioning of the lighting Adjust discharge distance to
needle 3-4mm
eak flame during lighting Clean the lighting needle
Blockages Inspect and remove obstacles
from the muzzle
2 3
INSTALLATION DIAGRAMS & INSTRUCTIONS CLEANING & MAINTENANCE
• Remove all wrapping straps, foam tray and/or other accessories. Place the pot in upright position on
the panel.
• Remove the dustproof cap before connecting the hosepipes.
• Station the stove at least 1.5cm away from other objects. Ensure a breathing space of at least 100cm
between all sides.
• The stove should at least be 50cm away from any gas cylinders, and the windpipe should be above
1.5m ITHOUT coming into contact with the furnace stack and across the oven hearth.
OPERATION PROCESS AND MODULATION
1. STARTING A FLAME
Set the gas knob to the “OFF” position, and turn on the gas source switch.
Follow the diagram on the right side; push the knob inward and turn
anticlockwise you will hear a ‘click’ sound indicating that the pointer is lit.
Release the knob.
2. POWER MODULATION
Control the flame by turning the knob to either ‘MIN’ or ‘MAX’ position to increase
or decrease the flame intensity. The pointer facing the wide area represents
HIGH power whilst the one facing the narrow area represents LO power.
3. POWER OFF POSITION
To power off, turn the knob clockwise to the ‘OFF’ position. Ensure the gas
source is also turned off as an added security measure.
4. WIND POWER MODULATION
If the flame becomes unstable, adjust the damper under the stove to regulate it.
CAUTION
1. Ensure that the type of gas type corresponds to that displayed on the label. DO NOT USE if it is
different.
2. hen using the gas stove, ensure that your kitchen is well ventilated and should preferably be
installed with an exhaust fan.
3. If a gas leak occurs, turn off the gas source IMMEDIATELY. Open the door and windows to ventilate
the kitchen. DO NOT operate any electronic equipment to ventilate the kitchen as there is a risk of
a fire hazard.
4. DO NOT place any flammable objects near the gas stove.
5. This appliance is intended for home use only.
1. Clean the gas stove regularly.
2. Replace hoses and pipes after one and a half years due to normal wear and tear to prevent gas
leakages
TROUBLESHOOTING
MGS-8312G(IM)220814_Layout 1 8/22/14 3:28 PM Page 2
