MORI EPC-260 User manual
MANUAL
EPC-260
Electric Palm Cutter
Please read the following instruction carefully before
operate this machine to ensure safety operation.
SYMBOLS & TEXT
Read the manual before Wear sturdy boots with non-slip soles.
Use.
Wear gloves made of durable Wear helmet, goggles and ear-muffs.
material for work
Do not expose to rain and use Store and battery charging indoors.
in damp environment.
Always remove battery from This product must be deposited at an
machine after use. appropriate recycle facility.
Keep all bystanders 15 meters away. Keep clearance of any electric facilities.
CONTENTS
Specification P1
Installation P2
Operation P3
Power Unit Panel P4~5
Battery P5
Charger Panel P6
Trouble Shooting P7
Maintenance P8
~
SPECIFICATION
Specification
Model Code
EPC-260
Battery Volt
36 volts
Battery Capacity
5.2 Ah
Battery Weight
1.4 kgs
Machine Weight (w/o battery)
5.7 kgs
Motor rpm
8500 rpm
Pipe length
1500 mm
The data may be slightly different due to
environment and cutting objects.
INSTALLATION
Palm Cutter Gearset
Operation Instruction
1. Install the battery at the power unit and slide to the end. (Figure 1)
2. Slide the power switch to turn on the machine. (Figure 2)
3. Press down the lockout device for control trigger.
4. Pull the trigger to control motor speed.
5. If the blade is stuck with palm tree, release trigger and switch off the machine.
Remove blade from palm tree and restart.
6. Switch off the machine while taking break or stop operating.
7. Wear the proper protection during operation.
8. Remove battery from machine after use and store separately. Full charge the battery for
next operation.
Any impact on blade or machine during operation, please
switch off machine and check if there is any damage.
Any damage to blade please replace blade immediately
to avoid injury.
Switch off and remove battery from machine while
changing blades or machine maintenance.
Full charge the battery for next operation and avoid to keep
battery in low voltage.
Switch
Lockout Device
Power Trigger
POWER UNIT PANEL
L0
L1
L2
Seq.
STATE
ILLUSTRATION
LIGHT INDICATION
1
Normal
When battery is attached, switch on
the machine and panel shows battery
capacity。
○
G
○
G
○
G
100％
Capacity
60％
30％
L0
L1
L2
Power
○
G
○
G
○
G
○
R
2
Overloading
When blade is stuck with palm tree,
red light is flashing and alarm.
SOLUTION：Remove blade from palm tree
and restart.
R
FLASHING
○
R
3
Overheated
Continues overloading cause motor or
battery is over heated. Red light
is flashing and alarm.
SOLUTION：Switch off the machine and
wait for motor or battery is cool
down.
R
FLASHING
○
R
4
Low volts
alarm
When battery volt is low then red light is
flashing and alarm.
SOLUTION：Switch off and recharge the
Battery.
R
FLASHING
○
R
5
Idle Alarm
When machine is switched on and idle
for over 3mins without using, Red
light is flashing and alarm.
(Power Saving Alarm)
SOLUTION：Switch off and restart.
R
FLASHING
R
FLASHING
R
FLASHING
○
R
SWITCH
LOCKOUT DEVICE
TRIGGER
Seq.
STATE
ILLUSTRATION
6
Operating
Switch on the power, press down the lockout device and pull the trigger, the
motor output will reach 8500rpm.
7
Emergency
Switch off the machine for cutting off the power supply when machine in not under
controlled.
BATTERY
BATTERY SPECIFICATION
Capacity
5.2Ah
Weight
1.4Kg
Standard Volt
36V
Charging Volt
42V
Charging Method
CC –CV
Charging Ampere
3A
Output Ampere
18A (Max)
1. The machine is compatible with MORI battery only.
2. Use MORI charger for charging only.
3. Ensure the battery is full charged at the 1st time use.
4. Avoid rain or damp environment.
5. Storage environment 5˚C ~ 40˚C without direct
sunlight.
6. Charging environment 5˚C ~ 40˚C.
7. Keep battery internal dry.
8. Ensure battery is full charged before storage.
9. If battery is stored over 3months without use, please discharge and recharge battery once.
(Keep machine running till battery volt is low then recharge battery fully)
CHARGER PANEL
Charger Instruction：
1. The charge is compatible with MORI battery only.
2. The charge is compatible with MORI adaptor only.
3. Avoid rain or damp environment which charging.
4. Keep charging environment 5℃~ 40℃.
5. Unplug the power supply after charging.
6. Do not expose the charger to microwave or high pressure environment.
Seq
State
Illustration
Charger Panel
Light
1
Standby
When power supply is plugged into the socket, the green light is on
till battery is attached.
Green Light
On
2
Charging
The red light is on till battery is full charged.
Red Light
On
3
Full
Charged
The green light is on when battery is full charged.
Green Light
On
4
Alarm
The red light is flashing when battery or charge is inoperative.
SOLUTION：Unplug the power supply and re-plug into the socket.
If the problem is not solved please contact local dealer.
Red Light
Flashing
Please use MORI charger only.
Ensure the AC socker is functional before charging.
Do not charge battery in damp environment.
Light
TROUBLE SHOOTING
State
Root
Solution
Switch on and machine is not
functional.
Battery is in low capacity
Fully charge the battery.
Battery is over 40℃or under 0℃
Move machine and battery to environment
0~40℃and restart.
Battery is not functional.
Remove battery and reattach to machine.
If the problem is not solved, please use
another battery and try again.
Machine is not functional.
Remove battery and reattach to machine.
If the problem is not solved, please
contact local dealer.
Suddenly shut down during operation.
Battery is over heated.
Remove battery from machine.
Make battery cool down and try again.
Electrical signal.
Reboot machine.
Charger light is flashing.
Battery is defective.
1. Reconnect adaptor and charger cable
then try again.
2. Take another battery and retry.
Charger is defective.
1. Reconnect adaptor and charger cable
then try again.
2. If problem is not solved please
contact local dealer.
MAINTENANCE RECORD
TEAM MACHINERY CO., LTD. / TMC
No. 209, SHEN AN ROAD, CHANG HWA CITY, TAIWAN, R.O.C.
TEL:+886-4-7373668 FAX:+886-4-7371618 MFG ID : 28643855
E-mail : sales@trimmer.com.tw URL : www.trimmer.com.tw
TMC MORI © 1997-2008 Team Machinery Co., Ltd. All Rights Reserved
Table of contents
