Morris S70148SP User manual

Instruction Manual
Refrigerator
MODEL: S70148SP
W70147SP

1
Dear customer:
Thank you for buying this refrigerator. To ensure that you get the
best results from your new refrigerator, please take time to read
through the simple instructions in this booklet。
Please ensure that the packing material is disposed of in
accordance with the current environmental requirements。
When disposing of any refrigerator equipment please contact
your local waste disposal department for advice on safe disposal。
This appliance must be only used for its intended purpose。

2
CAUTION :
The appliance is not intended for use by young children or infirm
persons without supervision。
Young children should be supervised to ensure that they do not
play with the appliance。

3
General
This type of refrigerator is widely used in places such as
hotels ,offices, student dormitories and houses. It is mostly
suitable for preserving foods such as fruits and beverage. It
enjoys the advantages of small size, lightweight, low electric
consumption and easy use。

4
Main configuration：
1、Thermostat
2、Glass shelf
3、Plastic pallet
4、Crisper
5、Leveler leg
1
2
4
3
5

5
UNPACKING YOUR REFRIGERATOR
WARNING: Use two or more people to move refrigerator.
Failure to do so can result in back or other injury.
·Remove tape and any labels from your refrigerator before
using(except the rating label).
·To remove any remaining tape or glue, rub the area briskly with your
thumb.
·Tape or glue residue can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
·Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can
damage the surface of your refrigerator.
·When moving the refrigerator, do not tilt the refrigerator beyond
45°from upright position.
CLEANING BEFORE USE：
After you remove all of the packaging materials, （especially the
foam between outside condenser and cabinet should be removed）
clean the inside of your refrigerator before using it.
SPACE REQUIREMENTS
WARNING: Keep flammable materials and vapors, such as
gasoline, away form refrigerator.
Failure to do so can result in death, explosion, fine or burns.
·To ensure proper ventilation for your refrigerator, allow for 200mm
space on each side between walls, 200mm space between back of
your refrigerator and the wall, and 300mm space between counter
top and the roof or ceiling.

6
·If you are installing your refrigerator next to a fixed wall, leave
sufficient space on the hinge side to allow for the door to swing
open.
·Never install your refrigerator near heat source and direct sun shins.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or
electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection.
Recommended Earthing Method
A 220～240 Volt /50 Hz AC only 10 ampere fused and properly
earthed electrical supply is required. It is recommended that a
separate circuit serving only this appliance be provided. Use a
receptacle which cannot be turned off with a switch or pull chain. Do
not use an extension cord.
NOTE: Before performing any type of installation, disconnect the
refrigerator from the electrical source. When you are finished,
connect the refrigerator to the electrical source and reset the control
to the desired setting.
LEVELING
If the refrigerator is not leveled during installation. The doors may not
close or seal properly, causing cooling, frost, or moisture problems. It

7
is very important of the refrigerator to be level in order to function
properly.
To level your refrigerator you may either turn the level leg clockwise
to raise that side to the refrigerator or turn counter –clockwise to
lower that side.
NOTE: Having someone push against the top of the refrigerator take
some weight off the leveling leg. This makes it easier to adjust the
leveling leg.
USE OF THE APPLIANCE
To obtain the best possible results form your refrigerator, it is
important that you operate it properly.
Temperature Control
Controls for the refrigerator and freezer are located at the fop shelf of
the refrigerating compartment. When you first install your
refrigerator, set the Thermostat knob at 3. Give your refrigerator
time to cool down completely before adding food. It is best to wait 24
hours before adding food.
The thermostat knob controls the temperature. The higher number
setting, the longer the compressor will run to keep the temperature
colder.
When the thermostat control knob is set to OFF, the refrigerator is
not running,
Fresh Food Storage
Wrap or store food in the refrigerator in airtight and moisture –proof
material. This prevents food odor and taste transfer throughout
refrigerator.
·Fruit – wash, let dry and store in refrigerator in

8
plastic bags or crisper.
·Leafy vegetables- Remove wrapping and trim or tear off
bruised and discolored areas, wash in
cold water and drain. Place in plastic
bag or plastic container and store in
crisper.
·Fish – Use fresh fish the same day as
purchased.
·Meat – Store most meat in original wrapping as
long as it is airtight and moisture –proof.
Re –wrap if necessary.
·Leftovers –Cover leftovers with plastic wrap or
aluminum foil.
Plastic containers with tight lied can also
be used.
Frozen Food Storage
The freezer compartment is designed for storing frozen food and for
freezing food at home.
Successful freezing depends on the correct packaging. When you
close and seal the package you must not allow air or moisture in or
out. If you do, you could have food odor and taste transfer
throughout the refrigerator, and also dry out frozen food.
Note: Never put bottled food or drinks in the freezer compartment.
For best performance, leave enough space in the freezer and
refrigerator compartment for air to circulate around the
packages. Also let enough room at the front so the door can
close tightly.

9
Defrosting
Refrigerator compartment –Defrosting process is automatic
by thermostat knob Melted frost
flow into drip tray and automatic
evaporating.
Freezer compartment –Defrosting for the freezer
compartment is by manual
process.
·Turn the thermostat knob to set at OFF position and leave open the
freezer door.
·Remove all foods, ice cube tray and shelf or transfer to refrigerating
compartment.
·Clean and wipe out the melted frost with a cloth.
·After defrosting, turn thermostat knob to origin position.
Note: To avoid damaging the freezing compartment wall, do not use
any sharp objects to remove the frost or separate the frozen
food.
Cleaning your refrigerator
Before you start to clean your refrigerator remove the mains plug
from the power supply.
Use a clean sponge or soft and a mild detergent in warm water. Do
not use abrasive or harsh cleaners.
Hand wash, rinse and dry all surfaces thoroughly.
Do not use cleaning waxes, concentrated detergents, bleaches or
cleaners containing petroleum on plastics and rubber parts.
Never use paper towels, window sprays, scouring cleansers or