Morris T71525D User manual

Morris


Energy SavingTips
gThe appliance should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
gLet hot foods cool to room temperature before placing in the appliance. Overloading the appliance
forces the compressor to run longer. Foods that freeze too slowly may lose quality, or spoil.
gBe sure to wrap foods properly, and wipe containers dry before placing them in the appliance. This
cuts down on frost build-up inside the appliance.
gAppliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling. Liners
interfere with cold air circulation, making the appliance less efficient.
gOrganize and label food to reduce door openings and extended searches. Remove as many items as
needed at one time, and close the door as soon as possible.
14

How to Use this Water Dispenser
Warning
1.Only purified and cold boiled water have access to this water dispenser, and the two kinds
must free from any impurity. Coke, apple juice and other soft drinks that contain Carbon dioxide
are forbidden.
2.It is not allowed to fill water when the water boxes is removed from the machine door.
3.Never fill more water than the maximum figure that indicated on the water box.
4.Check out whether the water box is on its foundation bed when you are not able to get water
normally as usual.
5.When you are trying to move the water box, be sure that there is no water in it.
6.You are not allowed to remove any element of the water valve.
7.When use the machine for the first time or it has been out of application for a long time, remove
and clean it up before you put it into application.
8.If water in this machine has been out of use for a long period, you had better to drain them out of
the dispenser and add pure water, and then it can be used as usual.
9.It is suggested that the product should be cleaned up every three to six months.
10.When you are cleaning this product, if cleaning solution is used, you had better put the water box
to its original position, and fill the water box, then you shall drain 5 to 6 cups of water, in case that
there is any rudimental dirt of water dispenser instruction after you used cleaning solution.
11.When you are opening or closing the door of the water dispenser, try to avoid overexerting in case
that water in the box move and overflows.
12.Do not touch the bottle frame above when adding water.
Instruction of water dispenser
Filling of drinking water:
Open the water box, open the water injection cover and then you can add water:
Steel wire fence string
Renovate tofill water
Water box cover
Water box body
Seal ring
Water valve elements
Water shall be filled here


How to Get the Drinking Water
1.Push the water shank inward by the cup
2.When you put the hand shank inward, there will be some water outflows,
when the hand shank is in its original position, no water outflows.
How to Remove and Clean up the Water Dispenser
First Step: remove
1.Take out the elements of the water box
Stick to both sides of the water box elements with both of your hands,
and draw out the elements of the water box outwards through 45 above.
You can translate the water box (to the side of the user) and get the
elements when the elements are out of water valve elements (when you
move the box, be sure that there is no water in it.)
2.Take down the seal ring of the water box elements


3.Step to remove the elements of water valve
Use the screwdriver and make the edge directs to the water valve elements
and then insert it in the free place that highlights outskirt, rotates the
screwdriver clockwise or anticlockwise, with the screwdriver moving, when it
tops the penstock, extracts the water valve elements by hands at the direction
of above 45e(You can not remove the elements of water valve)
Step 2: Clean up
1.Remove the water box itself, and the water box cover, the seal ring and the
water valve elements
2.Clean up the elements of the water box with cold or warm water.
3.Wipe out the water with dry cloth
Notes:
1.If you clean the water dispenser by cleaning solution, you had better put the
box to its originally position, and drain 5 to 6 cups of water out, then you can
use it normally, in case that thereis remaining dirt of application instruction.
Step 3: Installation
,QVWDOODWLRQRIZDWHUYDOYHHOHPHQWV
3XWWKHJX
LGHSURMHFWLQJSODWIRUPGLUHFWHGWRWKHJXLGHJURRYHDIWHUWKDWSXVK
LWGRZQVLGHZLWKeVODQWO\DWIX
OOWLOWXQWLO\RXKHDUDFUDFN


2.Installation of seal ring of the water box
Put the seal ring to the bottom of the water box, and be sure that the seal ring
is in place.Avoid that wrinkle seal ring or in wrong place.
3.The Installation of water box elements
To keep the hanging slot of the water box elements direct to the hangers on the
door liner. The seal ring at the bottom of the box shall directed to the entrance
of the water valve elements, insert it to the corresponding position along with
the 45eslantly
