MORryde JP54-041 User manual

www.MORryde.com • 574.293.1581
Heavy. Duty. Adventure.
INSTALLATION INSTRUCTIONS
Bolt-In KIt
Trail Kitchen Accessory: JP54-041
Step 5
Place plastic covers in the
clearance holes in the bolt-in
bracket to cover up the
hardware.
Step 4
Fasten bolt-in bracket into
rivnuts using (2) M6-1 x 30mm
socket head cap screws and
(2) supplied lock washers.
Step 3
Line up the holes of bolt-in
bracket with the (2) factory
rivnuts and 3/4" spacers located
behind the rear seat.
Step 2
Place (1) 3/4'' long spacer over
each factory rivnut where the
D-rings were previously located.
Step 1
Using a T45 socket, remove the (2)
factory D-rings closest to the back
seat and the next rear most D-ring on
the driver-side of the Jeep.
Tools Needed:
• T45 Torx Wrench/Socket
• 1/2" Wrench
• 5mm Allen Wench
JK
YJ
TJ
C J

Take your storage to the next level. Pair the Bolt-In Kit
with MORryde’s JK Storegate.
THE ULTIMATE STORAGE UPGRADE
www.MORryde.com • 574.293.1581
Heavy. Duty. Adventure.
INSTALLATION INSTRUCTIONS
Bolt-In KIt
Trail Kitchen Accessory: JP54-041
Step 1O
When deployed, adjust
leveling foot as needed to
level Trail Kitchen.
Step 9
Fasten Trail Kitchen to floor on
Jeep by installing the supplied
(1) M6-1 x 65mm bolt and (1) lock
washer through the remaining 1"
spacer and rivnut.
Step 8
Fasten Trail kitchen to bolt-in
bracket using supplied (4)
5/16-18 x 1'' bolts.
Step 7
Align mounting holes in Trail Kitchen with desired mounting holes in bolt-in bracket:
• Rear-most hole pattern (using Jeep as reference) is for use without a MORryde Storegate.
•Front-most hole pattern is for use with a MORryde Storegate.
JK
YJ
TJ
C J
Step 6
Install leveling foot into passenger-side mounting rail of Trail Kitchen (as shown), placing supplied
1/2'' long spacer between kitchen and foot. Secure the foot using supplied 5/16-18 center lock nut.
• If the Jeep is equipped with a floor-mounted subwoofer, install the leveling
foot in the second rear-most hole in passenger-side mounting bracket.
• If Jeep is not equipped with a floor-mounted subwoofer, install the leveling
foot in the rear-most hole in the passenger-side mounting brackent.