Movincool Climate Pro K36 User manual

1
No. Part Name Climate Pro K36 Climate Pro K60 Climate Pro K63
Warm Air Flexible Duct LAY45820-0010 LAY45820-0010 LAY45820-0010
Ceiling Tile Kit 484490-1040 484490-1040 484490-1040
Condenser Air Plenum 484350-1230 484350-1240 484350-1240
Accessory Installation Manual
484007-5030
WARNING
Disconnect power before installation. Beware that some residual voltage may remain in the unit
after the power is disconnected. There is a risk of electric shock.
Application Required Accessories Page No.
Aachment of Warm Air Flexible Duct 2
Aachment of Condenser Air Plenum 2 - 4
B
C
AA
B

2
ATTACHMENT OF WARM AIR FLEXIBLE DUCT
1. Place the warm air flexible duct over the accessory
ceiling tile flange and secure the duct with the
clamp.
3. Place the other duct end over the flange on top of
the unit or plenum. Secure the duct with the clamp.
2. Remove the original ceiling tile and install the ceiling
tile with duct. Use the tabs with holes to secure the
tile in place in case ceiling T-bar is too narrow or
weak.
ATTACHMENT OF CONDENSER AIR PLENUM
1. Separate the frame and plenum by removing the four (4) bolts.
Flexible Duct
Ceiling Tile Clamp
Flange
Plenum Frame
Plenum with Frame
Bolt (4)
Flexible Duct
Ceiling Tile
Flange
Clamp
Clamp
Tab

3
2. Open the side panel and remove it by liing
upward.
3. Loosen the boom two (2) screws and remove the
three (3) screws from the side of the unit.
4. Slide the lower brackets of the frame over the loosened screws and secure the five (5) screws to aach
the frame to the side of the unit.
Loosen Screws
(
2
)
Remove Screws (3)
Side Panel
Screw (5)
Frame
Bracket

4
5. Remove the two (2) knob bolts and remove the plate from the plenum by liing upward.
6. Insert the filter panel into the plenum as shown.
7. Reinstall the plate and secure it with the two (2) knob bolts.
4. Insert the four (4) brackets of the plenum into the slots of the frame and secure the plenum to the
frame with the four (4) bolts, which were removed in step 1 on page 2.
CAUTION
Do not lean on the unit or move the unit when attaching the air plenum. This may cause injury or
damage to the unit due to toppling.
Plate
Knob bolt (2)
Bolt (4)
Frame
Plenum
Bracket (4)
Slot
Filter Panel